Abstract:Research vessels are commonly used on a daily basis for ocean exploration and payload handling. However, due to unpredictable wave motion on the ship and the flexibility of the cable, the heave of the ship is unavoidable and causes danger during operations, loss of payload, possible damages to expensive equipment and prolong period of downtime. A compensator system is an essential part of operations to mitigate this effect and to ensure safety, reduce down-time of operation and increase efficiency while providing longer and better duration of operation even in harsh conditions. In this article, a passive heave compensator system with cylinder, accumulator and depth compensator connected in series by pressured pipes developed for a scientific research ship with length of 68m and breath of 16m is analyzed along the coast of Guyana, South America. The payload used in this analysis is 200 ton. The working principle of the heave compensation system is described, the parameters affecting the performance of the system are simulated and analyzed using MatLab. A 3D model of the system is built using SolidWorks and schematic drawings are produced from AutoCAD. The compensation rate of the system is higher than 77% under the influence of the input wave and the system has a response of an average setting time of 18s. The point of maximum load exerted is at the splash zone. For a typical most probable extreme significant wave height, Hs= 2.3m, period T= 6s and direction μ= 45° in the operational area, the reduction in heave motion when the vessel is equipped with the heave compensator is approximately 77% compared to 47% reduction when the vessel is without a compensator.

Model test of heave compensation system of deep-ocean mining

Nonlinear Control for an Active-passive Hybrid Compensation System

Nonlinear control of active heave compensator for an underwater towed system

Virtual prototype modeling and fuzzy control of the heave compensation system for a 500-ton deep-sea mining vessel

A Pressure-Displacement Control for an Active-Passive Hybrid Compensation System

Control Strategy for Performing Predictions for a Semi-Active Compensation System

State Constrained Variable Structure Control for Active Heave Compensators.

Scale model test of a semi-active heave compensation system for deep-sea tethered ROVs

Numerical simulation of a passive heave compensator for scientific research ships

Hybrid Model Testing Using Pre-Offset and Asymmetric Truncation Design for Deepwater Semi-Submersible with Highly Compliant Mooring System

Design of a Load Simulation System for Underwater Towed Heave Compensation System

Study on vessel–pipe coupling dynamic behavior under regular waves in deep sea mining process

Virtual model testing method for deepwater floating system

Numerical Simulation For Truncated Model Tests of Deepwater Semi-submersible Platform With Viscous Damper Compensated System In Mooring Lines

Truncated Model Tests for Mooring Lines of A Semi-Submersible Platform and Its Equivalent Compensated Method

A Numerical Investigation On The Effect Of Heave Motion Frequency In The Deep Sea Mining System

On electro-hydraulic lifting control system with heave compensation

Effects of Heave Motion on the Dynamic Performance of Vertical Transport System for Deep Sea Mining

Nonlinear Multi-Body Dynamic Modeling and Coordinated Motion Control Simulation of Deep-Sea Mining System

Active Heave Compensation Control of Rovs

Simulative Analysis for Deep Seabed Mining Lifting Systems