Abstract:It has long been known that hydrogen impurities can be incorporated in the structure of nominally anhydrous minerals (NAMs) and substantially influence their physical properties. One of the geologically most prominent NAMs is feldspar. The hydrogen concentration in NAMs is usually expressed in parts per million of water by weight (ppm H2O wt.) In this paper, we use the term “hydrogen” for uniformity, except when we use “water” for describing its amount expressed as parts per million of H2O by weight. In our article (Liu et al., 2018), we carried out in situ high-temperature X-ray powder diffraction and Raman spectroscopic studies on three natural anorthoclase samples with similar Or (K-feldspar) contents (Ab67Or31An2, Ab66Or31An2, and Ab65Or33An3) and Al–Si disordering but contrasting water contents. The spectroscopic results suggested that the displacive phase transition temperature is higher for the nearly anhydrous anorthoclase sample than the anorthoclase samples with about 200 ppm water, and we thus concluded that hydrogen is another factor impacting the displacive phase transition temperature. We thank Kroll and Schmid-Beurmann for pointing out the weakness in our interpretation that hydrogen is a possible important factor (Kroll and Schmid-Beurmann, 2020). To clarify this issue, we conducted transmission electron microscopy (TEM) experiments on the three samples to check texture effects. The TEM studies indicated that the nearly anhydrous anorthoclase sample consists of two feldspar phases, a K-poor and a K-rich one, and that the K-poor area may be responsible for the higher displacive phase transition temperature. According to the observation that the temperature of redistribution of hydrogen is accordant with the displacive phase transition temperature, the effect of hydrogen could not be ruled out. Based on these results, it can be concluded that hydrogen may not be the sole possible factor, and it was a proposition more than a definitive proof for the moment. Natural feldspars are complex, and factors affecting displacive phase transitions are multiple (e.g., Salje et al., 1991; Harrison and Salje, 1994; Hayward and Salje, 1996; Dobrovolsky et al., 2017). Therefore, to further investigate hydrogen effects on displacive phase transition in feldspar, synthetic samples with pure chemical compositions and hydrogen species are necessary. In the following, we address each issue in the same order as in the comment by Kroll and Schmidt-Beurmann (2020).

Study on Interaction Between the Feldspar and CO2 Fluid

Fluidization of Cohesive Fluorite Particles at Ambient/High Temperatures and Enhancement Methods

Revealing the Effect of O2, SO2 and H2O in Supercritical CO2 on the Corrosion Behavior of 316L Steel at Elevated Temperature

Impact of the Mineral Composition and Sintering Temperature on the Synthesis of Anorthite Ceramics

Temperature Dependences of Hydrous Species in Feldspars

Impact of Fluorine on the Thermal Stability of Phlogopite

Hydrothermal decomposition of K-feldspar in KOH–NaOH–H 2 O medium

Impact of secondary coatings on the dissolution rate of K-feldspar: A combined experimental and modeling study

The complex effect of organic acids on the dissolution of feldspar at high temperature

Thermodynamic mechanism and its geological significance in the transformation of albite under inorganic acid environments based on the total dissolution model

Reply to Kroll and Schmid-Beurmann's Comment on &amp;#8220;water Decreases Displacive Phase Transition Temperature in Alkali Feldspar&amp;#8221; by Liu Et Al. (2018)

Water Decreases Displacive Phase Transition Temperature in Alkali Feldspar

Electrical Conductivity of K-feldspar at High Temperature and High Pressure

Experimental Studies on the Interactions between Dolomite and SiO2-rich Fluids: Implications for the Formation of Carbonate Reservoirs

Evolution of Oh Groups in Diopside and Feldspars with Temperature

An experimental study of H solubility in feldspars: Effect of composition, oxygen fugacity, temperature and pressure and implications for crustal processes

An experimental study on water-rock interaction during water flooding in formations saturated with CO_2

Study of Carbon Dioxide Corrosion Products by X-Ray Diffraction

An Experimental Study of the Formation of Talc Through CaMg(CO3)2–SiO2–H2O Interaction at 100–200°C and Vapor-Saturation Pressures

Experimental Modeling of Interaction between Fluorine-Containing Granite Melt and Calcite Marble

The Dissolution Behavior of Feldspar Minerals in Various Low-Molecular-Weight Organic Acids