Abstract:This paper presents a novel on-chip passive bandpass fllter for millimeter-wave (MMW) applications that utilizes a pair of electrically-coupled thru-silicon vias (TSV). The presented TSV bandpass fllter can be used in MMW applications such as radar, medical imaging, and communication. The TSV bandpass fllter uses two TSVs to extend two electrically-coupled conductors into the silicon substrate in the z-direction instead of horizontally in the x-y plane. There is a metal layer on the bottom side of the silicon substrate that shorts the ends of the two TSVs to ground. Using TSVs in the bandpass fllter design reduces the silicon area required to implement the fllter compared to the silicon area required for the equivalent conventional fllter in the above-silicon metal-dielectric interconnect stack. The operating performance of the bandpass fllter is controlled at the design stage by choosing the separation distance between the TSVs. In this work, the two TSVs were 145"m in height (z-direction) and 3"m £ 50"m in the x-y plane. The long edges of the TSVs (50"m long edges) faced each other to maximize capacitance coupling between the TSV pair. The TSVs were separated by a distance of 5"m. Full-wave electromagnetic simulations of a TSV fllter designed in an IBM SiGe technology that included TSVs show a minimum pass-band insertion loss of i3:9dB at 77GHz with a usable pass band from 75{85GHz is possible. The simulated operating range of the TSV bandpass fllter design presented in this paper show that it is well suited for automotive radar applications.

A 1V active-RC complex filter for wireless sensor networks application

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

An Active-RC Complex Filter with Mixed Signal Tuning System for Low-IF Receiver

Scalable, Low-power and High-performance Active-RC Complex Band-Pass/Low-Pass Filter with Automatic Frequency Tuning Applied to the Internet of Things

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

Substrate Integrated Waveguide Filter with Flat Passband Based on Complex Couplings

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A wide tuning range Active-RC filter for multi-mode applications

A Reconfigurable CBP/LP Active RC Filter with Noise-Shaping Technique for Wireless Receivers

Low-Power IF Complex Filter with on-Chip Tuning Circuit Based on PLL

A Configurable Active-Rc Filter for Half-Duplex Transceiver

A CMOS Polyphase Low-if Filter with On-Chip Frequency Control

Second Order Low Pass RC Active Filter for Low Frequency Signal Processing

A 5.7mw +30dbm IIP3, Tunable Active-RC LPF in 40nm CMOS

An Image-Rejection Complex Filter with Low Power Based on Transconductance-Resistance-Capacitance Cells

A Q-Enhanced CMOS RF Filter for Multi-Band Wireless Communications

A 2.3mA 240-to-500MHz 6th-order active-RC low-pass filter for ultra-wideband transceiver

A Novel Compact Thru-Silicon-Via On-Chip Passive Mmw Bandpass Filter for 77ghz Applications

The Design Of High-Frequency Ota-C Filter For Wireless Sensors Network Applications

A Highly Reconfigurable 5th Order Active RC Filter for Multi-standard Wireless Receivers in 12-nm CMOS

A 5.8ghz Band-Pass Filter with an Active Inductor Through 0.18μm Full-CMOS Process for Wireless Transceivers