Abstract:In-vehicle wireless networks are crucial for advancing smart transportation systems and enhancing interaction among vehicles and their occupants. However, there are limited studies in the current state of the art that investigate the in-vehicle channel characteristics in multiple frequency bands. In this paper, we present measurement campaigns conducted in a van and a car across below 7 GHz, millimeter-wave (mmWave), and sub-Terahertz (Sub-THz) bands. These campaigns aim to compare the channel characteristics for in-vehicle scenarios across various frequency bands. Channel impulse responses (CIRs) were measured at various locations distributed across the engine compartment of both the van and car. The CIR results reveal a high similarity in the delay properties between frequency bands below 7GHz and mmWave bands for the measurements in the engine bay. Sparse channels can be observed at Sub-THz bands in the engine bay scenarios. Channel spatial profiles in the passenger cabin of both the van and car are obtained by the directional scan sounding scheme for three bands. We compare the power angle delay profiles (PADPs) measured at different frequency bands in two line of sight (LOS) scenarios and one non-LOS (NLOS) scenario. Some major \added{multipath components (MPCs)} can be identified in all frequency bands and their trajectories are traced based on the geometry of the vehicles. The angular spread of arrival is also calculated for three scenarios. The analysis of channel characteristics in this paper can enhance our understanding of in-vehicle channels and foster the evolution of in-vehicle wireless networks.

Measured Channel Capacity of SIMO-UWB for Intra-Vehicle Communications

Performance of Intra-Chip Wireless Interconnect Using On-Chip Antennas and UWB Radios

Experimental evaluation of high speed impulse radio UWB interference on WiMAX narrowband systems

Vehicular Communications: A Physical Layer Perspective

Information-Theoretic Limits of Integrated Sensing and Communication with Correlated Sensing and Channel States for Vehicular Networks

Multiple-Frequency-Bands Channel Characterization for In-vehicle Wireless Networks

Intelligent Surface Enabled Sensing-Assisted Communication

Channel Measurements and Modeling for Dynamic Vehicular ISAC Scenarios at 28 GHz

Use of UWB Impulse Radio Technology in In-Car Communications: Power Limits and Optimization

Cross Evaluation of Multiple Access Schemes Using Post-Experimental Field Data for Underwater Acoustic Communications

Measurement-Based Analysis of Channel Capacity in Aircraft Cabin Distributed Mimo System

A Fusion Strategy for Vehicle Positioning at Intersections Utilizing UWB and Onboard Sensors

Capacity-Approaching Transceiver Design For Asymmetric Uwb Links

Measurement and characterization of ultra-wideband wireless interconnects within active computing systems

Non-stationarity Characteristics in Dynamic Vehicular ISAC Channels at 28 GHz

Time-division ISAC Enabled Connected Automated Vehicles Cooperation Algorithm Design and Performance Evaluation

Characterization and modeling of high-speed underwater acoustic communication channels

A Performance Study of Spatial Modulation Systems under Vehicle-to-Vehicle Channel Models

Capacity and spatial correlation measurements for wideband distributed MIMO channel in aircraft cabin environment

Millimeter Wave V2V Communications: Distributed Association and Beam Alignment

Channel Estimation for IRS-Assisted mmWave Vehicle-to-Vehicle Communication Systems