Abstract:The drum -shaped honeycomb -type III cable dome with a quad -strut layout abandons the traditional concept, incorporating a multi -support pole concept, making it one of the most structurally diverse types of cable dome structures. Its upper chord cable mesh is evenly divided, resulting in a simple and efficient structural design. This design approach reduces the usage of cables and struts, making pre -stressing and tensioning construction more convenient. Furthermore, the structure exhibits good cost-effectiveness. Based on the node force equilibrium equations, a general formula is derived for calculating the internal forces of prestressed cables and struts in the prestressed state of the structure. Additionally, the variation of prestress distribution with geometric parameters of the cable dome structure is analyzed. A numerical model with a span of 120 meters was established in the general finite element software Ansys to investigate the influence of structural parameters on the structural natural frequency characteristics. Moreover, using the nonlinear dynamic analysis method, the dynamic response of the structure under multidimensional seismic loads was compared and analyzed. The research results indicate that the prestress distribution of the structure is reasonable, with a greater amount of prestress in the outer ring compared to the inner ring. This observation suggests that the stiffness of the structure is primarily supported by the outer ring structure. The structural natural modes of vibration predominantly exhibit vertical deformation, indicating that the vertical stiffness of the structure is weaker than the circumferential direction. Furthermore, when subjected to seismic loading, the internal forces in cables and struts, as well as the dynamic displacements of key nodes, are relatively small, demonstrating excellent seismic performance.

Simplified Techniques for Prestress Design and Load Analysis of Geiger Domes

Simple approach for force finding analysis of circular Geiger domes with consideration of self-weight

A Fast Calculation Method for the Initial Prestress Distribution of Rib Ring Cable Dome

Prestress Design of Cable Domes with New Forms

Analytical Study of Structural Conformation and Prestressing State of Drum-Shaped Honeycomb Quad-Strut Cable Dome Structure with Different Calculation Methods

Sensitivity Analysis of Suspen-Dome on Imperfect State

Dynamical characteristics research on cable dome

Study on Prestress Distribution and Structural Performance of Heptagonal Six-Five-strut Alternated Cable Dome with Inner Hole

Integral feasible prestress of cable domes

Geometry-based Construction Technique and Application of Geiger Type Cable Dome

Natural Vibration and Wind-Induced Response Analysis of the Non-Fully Symmetric Geiger Cable Dome

Distribution of Initial Pre-Stress and Stability Analysis of Suspen-Dome

Manufacture Error and its Effects on the Initial Pre-Stress of the Geiger Cable Domes

Conformation and static performance analysis of pentagonal three-four strut hybrid open-type cable dome

STRUCTURAL MORPHOLOGY AND DYNAMIC CHARACTERISTICS ANALYSIS OF DRUM-SHAPED HONEYCOMB-TYPE III CABLE DOME WITH QUAD-STRUT LAYOUT

Experimental research on construction of a Kiewitt dome model pre-tensioned by different schemes

Nonlinear analysis and optimum design of cable domes

Dynamic Analysis of Suspend-Dome

New Forms And Methods For Analysis And Construction Of Cable Domes

FAILURE MODE AND BEHAVEIOR ANALYSIS OF TWO TYPES OF CABLE DOMES

Approximate optimization and performance analysis of rigid cable dome structure