Abstract:Modified calcium bentonite (Ca-bentonite) is extensively used in engineered barrier systems (EBSs) for municipal and industrial disposal sites due to its high swelling potential and low hydraulic conductivity. However, few studies have focused on the micromechanism of hydration and swelling under the effect of inorganic chemical solution. In this study, free swell index (FSI) and the type and content of modified Ca-bentonite bound water under the inorganic chemical solution were quantitatively studied by using the free swell test and nuclear magnetic resonance (NMR). According to the results, modification of sodium and polymer significantly increases the FSI of Ca-bentonite, bringing it close to that of natural sodium bentonite. In addition, the chemical stability of polymer-modified bentonite is significantly higher than that of sodium-modified bentonite but less than that of natural Na-bentonite. The FSI of modified Ca-bentonite decreases with the increase of cation valence and ionic strength. T 2 distribution curves of the two types of modified bentonite are three-peak curves. With the increase of ionic strength, the content of total water and permeated hydrated water (accounting for 69%–95%) in bentonite decreases gradually, whereas the surface hydration water (accounting for 2%–31%) and free water content (accounting for 0–15%) increase. A uniform linear relationship exists between the FSI and corresponding total peak area of NMR (independent of ion valence, concentration, and bentonite type). Furthermore, a linear relationship exists between the FSI of the same type of bentonite and the T 2 relaxation time. Research results can provide data and theoretical basis for quantitative analysis and mechanism of the hydration swelling of bentonite.

Synthesis and Characterization of Ctmab and Pdmdaac Modified Organobentonite

Adsorption of Congo Red Dye Onto Raw and Chitosan-Modified Bentonite

Phenol Adsorption Mechanism of Organically Modified Bentonite and Its Microstructural Changes

Adsorption of Pb (II) from Aqueous Solution by Modified Bentonite

Modified Conditions of Organobentonite for Adsorbing Organic Contaminants

Phenol adsorption properties and microstructural changes of organically modified bentonite

FT-IR and XRD Analysis of Natural Na-bentonite and Cu(II)-loaded Na-bentonite.

Studies on the properties and mechanism for organobentonites to adsorb organic compounds

Enhanced sorption of naphthalene and nitroaromatic compounds to bentonite by potassium and cetyltrimethylammonium cations.

Adsorption of Mixed Cationic-Nonionic Surfactant and Its Effect on Bentonite Structure.

Preparation of Organobentonite modified by Quaternary Ammonium Salt and Studies of Its Structure

Organobentonites as adsorbents for some organic pollutants and its application in wastewater treatment

Enhanced Organic Contaminant Retardation by CTMAB-Modified Bentonite Backfill in Cut-Off Walls: Laboratory Test and Numerical Investigation

Study on Sodium Montmorillonite Modified by Diallylmethyl Alkyl Ammonium Bromide

Transformation of the structure and adsorption properties of bentonite during physical and chemical treatment

Study on the Preparation of Low Cost Organoclay from Low-Level Ca-bentonite

Simultaneous adsorption of organic pollutant and heavy metal onto surfactant-modified organobentonites with chelating ligands

Property of dual-cation organobentonites to remove organic compounds from water

A new method for the preparation of modified bentonite used in organic wastewater treatment

Use Of Cetyltrimethylammonium Bromide Bentonite To Remove Organic Contaminants Of Varying Polar Character From Water

Studies on Hydration Swelling and Bound Water Type of Sodium- and Polymer-Modified Calcium Bentonite