Injection moulding optimisation of multi-class design variables using a PSO algorithm
Y.-M. Deng,D. Zheng,X.-J. Lu
DOI: https://doi.org/10.1007/s00170-007-1258-7
IF: 3.563
2007-01-01
The International Journal of Advanced Manufacturing Technology
Abstract:Injection moulding optimisation seeks to achieve the highest possible moulding quality under the specified constraints. To this end, the factors (design variables) affecting the moulding quality should be adjusted, including those of process parameters, mould design, part geometry, etc. Past work in this aspect is primarily focused on tuning the process parameters and mould design (e.g., gate location, runner and cooling channel layout), with less attention on the part geometry, and none on them all. To address this problem, this paper presents a PSO (particle swarm optimisation) algorithm for the optimisation of multi-class design variables, such as the part thickness, process parameters (melt temperature, mould temperature, injection time) and gate location. The optimisation is targeted at different aspects of moulding quality, including part warpage, weld lines, air traps, and so on. In applying the PSO algorithm, the paper proposes a modified elite archiving method, which can expedite the convergence speed, hence improving the efficiency of the algorithm. A computer program was developed that automates the steps such as adjusting the part thickness, the injection moulding process parameters and the gate location, activating the CAE software to simulate the injection moulding process, retrieving the simulation results, and evaluating the objective functions. The whole procedure iterates a number of generations by following the search process of the algorithm. A case study was also presented to illustrate as well as to test the proposed methodology, which was demonstrated as both effective and efficient.