Abstract:Musculoskeletal lower limb models are widely used to predict the resultant contact force in the hip joint as a non-invasive alternative to instrumented implants. Previous musculoskeletal models based on rigid body assumptions treated the hip joint as an ideal sphere with only three rotational degrees of freedom. An musculoskeletal model that considered force-dependent kinematics with three additional translational degrees of freedom was developed and validated in this study by comparing it with a previous experimental measurement. A 32-mm femoral head against a polyethylene cup was considered in the musculoskeletal model for calculating the contact forces. The changes in the main modelling parameters were found to have little influence on the hip joint forces (relative deviation of peak value < 10 BW%, mean trial deviation < 20 BW%). The centre of the hip joint translation was more sensitive to the changes in the main modelling parameters, especially muscle recruitment type (relative deviation of peak value < 20%, mean trial deviation < 0.02 mm). The predicted hip contact forces showed consistent profiles, compared with the experimental measurements, except in the lateral–medial direction. The ratio-average analysis, based on the Bland–Altman’s plots, showed better limits of agreement in climbing stairs (mean limits of agreement: −2.0 to 6.3 in walking, mean limits of agreement: −0.5 to 3.1 in climbing stairs). Better agreement of the predicted hip contact forces was also found during the stance phase. The force-dependent kinematics approach underestimated the maximum hip contact force by a mean value of 6.68 ± 1.75% BW compared with the experimental measurements. The predicted maximum translations of the hip joint centres were 0.125 ± 0.03 mm in level walking and 0.123 ± 0.005 mm in climbing stairs.

A Study on the Mathematical Model of a Hip Joint in a Normal Gait

The Movement Model of the Knee Joint during Human Walking

HIP MOTION ANALYSIS USING PARAMETRIC MATHEMATICAL MODELING IN MIDDLE AGED TO ELDERLY ADULTS DURING WALKING

The model analysis of the vertical motion parameters of the pelvis during human walking

Gait analysis of human locomotion based on motion capture system

An Approach to Modeling Leftward/rightward Motion Trajectory of the Pelvis

The Research of Differences in Hip Angle between Treadmill Walking and Ground Walking

Mathematics modeling and verification of hip joint surface contact stress

A PARAMETRIC MODEL OF THE PELVIC MOTION OF MIDDLE-AGED AND ELDERLY LOCOMOTION ON THE GROUND

Establishment of Dynamic Model of Human Knee Joint in Sagittal Plane.

Study on the Gait Motion Model of Human Lower Limb Joint

[Research of Kinematics and Kinetics Models of Human Knee Joint].

Analysis of Movement Characteristics and Tendon Parameters of Lower Limbs in Human Body

Simultaneous Estimation of the Vertical Stiffness in the Knee and Hip for Healthy Human Subjects During Walking

Modeling and Simulation of Musculoskeletal System of Human Lower Limb Based on Tensegrity Structure

Modeling And Analysis Of Human Lower Limb In Walking Motion

Motion Capture Based Dynamic Assessment of Hip Joint Cartilage Contact Pressure During Daily Activities.

A TWO-DIMENSIONAL MODELLING FOR HUMAN HIP STRESS ANALYSIS

Prediction of Hip Joint Load and Translation Using Musculoskeletal Modelling with Force-Dependent Kinematics and Experimental Validation

A 3-D Static Modeling for Evaluating Biomechanical Attributes at Human Hip Joint

Measurement Research of Normal Human Gaits