Design and testing of a high power piezo pump for hydraulic actuation
Nathan Sell,Tom Feehally,Andrew Plummer,Peter Wilson,Jonathan du Bois,Nigel Johnston,Jens Roesner,Andrea De Bartolomeis,Tom Love
DOI: https://doi.org/10.1177/1045389x241256830
IF: 2.7
2024-07-27
Journal of Intelligent Material Systems and Structures
Abstract:Journal of Intelligent Material Systems and Structures, Ahead of Print. Traditional valve-controlled hydraulic cylinders are usually very inefficient due to power loss through the control valve. An efficient alternative architecture is to distribute power electrically rather than hydraulically to a group of cylinders and drive each cylinder via individual servomotor-driven pumps. This arrangement is called electrohydrostatic actuation. Such actuators are currently available for power ratings of several hundred watts or greater, but not in the sub-100 W range. This paper details the design, simulation and testing of a piezopump which is intended to address this gap. The motivation is for aerospace applications, and in particular accessory actuators used in the landing gear system. The 10–100 W range is a high-power output for a piezopump, and to achieve this a novel design using disc-style reed valves was developed to allow pumping frequencies above 1 kHz. These high frequencies necessitated the development of custom power electronics capable of delivering 950 V peak-peak sine wave excitation to a largely capacitive load. Experimental results show that the piezopump is capable of delivering over 30 W of hydraulic power, and at no-load can deliver up to 2 L/min of flow at 1250 Hz. Future development includes a transition to multi-cylinder pumps, and improved reed-valve modelling to improve the accuracy of simulated performance.
materials science, multidisciplinary