Design and control of side-stream extractive distillation to separate acetic acid and cyclohexanone from wastewater by varying pressure
Jiyan Liu,Xinglong Liu,Jie Li,Junyao Ren,Jie Wang,Lanyi Sun
DOI: https://doi.org/10.1016/j.psep.2022.01.064
IF: 7.8
2022-03-01
Process Safety and Environmental Protection
Abstract:A large amount of wastewater containing acetic acid and cyclohexanone is produced during the production of ε-caprolactone. It is necessary to recycle acetic acid and cyclohexanone from wastewater. In this paper, the feasibility analysis for the separation of acetic acid/ cyclohexanone/ water with a near-azeotrope and an azeotrope which is pressure sensitive is carried out based on the residue curve map (RCM). And two sequences of conventional extractive distillation are determined. In order to prevent the remixing effect in conventional extractive distillation, four configurations of side-stream extractive distillation by varying pressure are proposed and optimized. The results show that the single liquid side-stream extractive distillation configuration SED1 is the optimal configuration in terms of economy, environmental protection, energy efficiency and safety. Compared with the optimal conventional extractive distillation configuration CED1, the total annual cost (TAC) of SED1 is reduced by 6.6%, and CO2 emissions are reduced by 11.9%. Subsequently, three proportion-integral (PI) control structures and a model predictive control (MPC) structure are proposed for SED1. The robustness and controllability of PI and MPC systems are compared by calculating integral absolute error (IAE). The findings indicate that the MPC structure has the best performance among all control structures.Download : Download high-res image (250KB)Download : Download full-size imageEmerging data indicates that incumbent mechanical/physio-chemical air handling systems inadequately address common indoor air quality (IAQ) problems, including elevated CO2 levels and volatile organic compounds (VOCs), with compounding negative impacts to human health. Preliminary research suggests that active plant-based systems may synthetically address these challenges. However, in order to design system performance parameters, the significance of species selection and biogeochemical mechanisms of growth media design need further characterization towards an effective bioremediative interface with air handling systems. Here, through three different species across three different growth media designs, we investigate trade-offs between CO2 sequestration through photosynthesis and CO2 production by metabolically active root-zones (that may remediate VOCs). Across the species, hydroponic media produced 61% greater photosynthetic leaf area compared to organic media which produced 66% more root biomass. CO2 concentration changes driven by differing plant and growth media (organic vs. hydroponic) treatments were measured within a semi-sealed chamber. Repeated estimations of net CO2 concentrations throughout plant development revealed decreasing influxes of CO2 within the chamber over time, indicating evolving photosynthesis/respiration balances. Multivariate analysis indicates growth media design, through impacts to water availability, air flow rates and plant development, was a more significant driver of bioremediation performance metrics than species selection.Chalcopyrite bioleaching has developed rapidly because of the advantages such as environmental protection, low capital investment and simple operation, but its application has been limited by the slow reaction rate and other problems. Bioelectrochemical system (BES) as a promising wastewater treatment technology could solve the problem of reaction abort due to insufficient electron acceptors inside the mineral heap. In this study, the effect of pulp density, anode material and silver ion on the copper bioleaching were carried out. Experimental results showed that the maximum bioleaching efficiency (1.70 ± 0.18%) in 11 d was achieved at a pulp density of 1% with the application of titanium-silver anode and the assistance of BES. BES promoted the bioleaching of Cu mainly by promoting the bacterial reproduction and the Fe2+ production from the chalcopyrite. Moreover, the introduction of BES promoted the release of Ag+, further enhancing the bioleaching of Cu by 1.5 times (187.7 ± 18.1 mg/L vs. 120.9 ± 22.2 mg/L). In addition, the inhibition of conductive silver glue on the copper bioleaching and bacteria was alleviated by the BES. As an anode material, carbon cloth couldn't improve the leaching of Cu as compared to titanium foam, but it could increase the electron transfer efficiency.Co-pyrolysis of oil shale and biomass can promote thermal decomposition and improve product quality because of the interaction. Therefore, the co-pyrolysis characteristics of oil shale ( -Abstract Truncated-
engineering, environmental, chemical