A Photomechanical Film in which Liquid Crystal Design Shifts the Absorption into the Visible Light Range
Sven Schultzke,Nikolai Scheuring,Pim Puylaert,Matthias Lehmann,Anne Staubitz
DOI: https://doi.org/10.1002/advs.202302692
Abstract:Liquid crystalline polymer networks (LCN) with azobenzene monomers bend reversibly under UV-light irradiation, combining photomechanical and photothermal effects. However, the harmful nature of UV-light limits their use in biology and soft robotics. Although visible light-absorbing tetra-ortho-fluoro-substituted azobenzenes exist, liquid crystalline monomers have never been prepared. Previously, such azobenzenes were added as photoactive additives (up to 10%) to otherwise passive liquid crystalline polymer networks. In this work, a molecular design of a liquid crystalline, polymerizable azobenzene switchable by visible light is presented. The monomer assembles in a highly fluid nematic phase, but polymerizes in a layered smectic C phase. The films are produced solely from the monomer without additional liquid crystalline components and are actuated with visible light. Bending experiments in air and under water differentiate photomechanical and photothermal effects. Remarkably, a 60 µm splay aligned film maintains its deformation for hours, slowly reverting over days. Monomer liquid crystallinity is characterized using differential scanning calorimetry (DSC), wide-angle X-ray scattering (WAXS), and polarized optical microscopy (POM); polymer films are analyzed using WAXS and DSC on a homogeneously aligned film. The synthetic procedure is high yielding and polymer film fabrication is scalable, which enables the use of safe and efficient photomechanical LCNs in soft robotics, engineering and biology.