Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Local Fixed Pivot Quadratue Method of Moment for Bubble Population Balance Equation Including Coalescence and Breakage

A Modified Bubble Breakage and Coalescence Model Accounting the Effect of Bubble-Induced Turbulence for CFD-PBM Modelling of Bubble Column Bubbly Flows

Influence of Grid and Numerical Schemes on Bubble Column Simulation with TBPBM-CFD Model

Numerical Investigation of Multi Rising Bubbles Using a Coupled Level Set and Volume of Fluid (CLSVOF) Method

The Instability of Monodisperse Bubbles Passing Through a Confined Geometry

Modelling of Mass Transfer for Gas-Liquid Two-Phase Flow in Bubble Column Reactor with a Bubble Breakage Model Considering Bubble-Induced Turbulence

Local Fixed Pivot Quadrature Method of Moments for Solution of Population Balance Equation

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

An Adaptive Direct Quadrature Method of Moment for Population Balance Equations

Solution of population balance equation using quadrature method of moments with an adjustable factor

Study on Direct Quadrature Method of Moment for Population Balance Equation in Isotropic Particle System

Numerical analysis of bubble characteristics in a pressurized bubble column using CFD coupled with a population balance model

Computational Fluid Dynamics–Population Balance Modeling of Gas–Liquid Two-Phase Flow in Bubble Column Reactors With an Improved Breakup Kernel Accounting for Bubble Shape Variations

Numerical simulation on motion of bubble under water

Numerical Solution on Spherical Vacuum Bubble Collapse Using MPS Method

Direct Quadrature Method of Moment on Characteristic Volume for Population Balance Equation

Theoretical and Numerical Studies on the Bubble Collapse in Water

Research on theoretical and numerical methods of single bubble oscillation

Study on Quadrature Method of Moment of Volume for Population Balance Model for Dispersed Phase System

A Boundary Element Method for the Simulation of Non-Spherical Bubbles and Their Interactions Near a Free Surface

Numerical Analysis of Gas Bubbles in Close Proximity to a Movable or Deformable Body