Abstract:Resistive Plate Chambers (RPCs), used for the Muon Spectrometer of the ALICE experiment at CERN LHC, are currently operated in maxi-avalanche mode with a low threshold value and without amplification in the front-end electronics. RPC detectors have shown a good operation stability with the current gas mixture during the entire Run 1 (2010$-$2013) and the ongoing Run 2 (2015$-$2018) at the LHC. The gas mixture is made up of $C_{2}H_{2}F_{4}$, $SF_{6}$ and $iC_{4}H_{10}$. Since the first two gases have high Global Warming Potentials (GWPs), there is the risk that they will be phased out of production in the next years, due to the recent restrictions and regulations of the European Union. Therefore, finding a new eco-friendly gas mixture has become extremely important in order to reduce the emissions of greenhouse gases. In addition, the present $iC_{4}H_{10}$ contribution makes the current gas mixture flammable. Non-flammable components, or at least in non-flammable concentrations, would be advisable to make the operation of detectors simpler and safer. In order to identify a gas mixture suited to cope with the requirements of the ALICE Muon Identifier in the forthcoming High-Luminosity runs, a dedicated experimental set-up has been used to carry out R&D studies on promising gas mixtures with small-size RPCs. Hydrofluoroolefins ($HFOs$) are appropriate candidates to replace the $C_{2}H_{2}F_{4}$ thanks to their very low GWPs, especially $HFO1234ze$ which is not flammable at room temperature. Several tests on $HFO$-based mixtures with addition of various gases are ongoing and encouraging results have already been obtained. Furthermore, the use of $CO_{2}$ as a quencher has been studied as it might represent a valid solution to avoid flammability of the mixture. Finally, medium-term stability of detectors exposed to the cosmic-ray flux will be shown in this paper.

Study of RPC Gas Composition Using Daya Bay RPCs

More environment-friendly and safer working gas mixtures for Bakelite RPCs operated in streamer mode

Study of RPC gas mixtures for the ARGO-YBJ experiment

Study on the Performance of the YBJ-ARGO RPC

Environment-friendly gas mixtures for Resistive Plate Chambers: an experimental and simulation study

Effect of variations in the gas mixture compositions on the timing and charge of glass RPC

Exploring Eco-Friendly Gas Mixtures for Resistive Plate Chambers: A Comprehensive Study on Performance and Aging

Studies of C 2 H 2 F 4 and SF 6 alternative gas mixtures for HPL RPC detectors for High Energy Physics applications

New RPC gas mixtures for sustainable operation in the CMS experiment

Characterization of new eco friendly gas mixtures based on HFO for RPCs

Gas related effects on multi-gap RPC performance in high luminosity experiments

R&D studies on eco-friendly gas mixtures for the ALICE Muon Identifier

Measurements of position-specific carbon isotopic compositions in propane by on-line Gas Chromatography-Pyrolysis-Gas Chromatography-Isotope Ratio Mass Spectrometer (GC-Py-GC-IRMS) and its preliminary application

The Mass Production and Quality Control of Rpcs for the Daya Bay Experiment

Preliminary results on the long term operation of RPCs with eco-friendly gas mixtures under irradiation at the CERN Gamma Irradiation Facility

Studies on tetrafluoropropene-CO2 based gas mixtures for the Resistive Plate Chambers of the ALICE Muon IDentifier

Improving the RPC rate capability

Studies on RPC Position Resolution with Different Surface Resistivity of High Voltage Provider

Layout and Performance of RPCs Used in the Argo-YBJ Experiment

Development of novel low-cost gas recirculation system for the RPCs chambers

Advances towards a large-area, ultra-low-gas-consumption RPC detector