Abstract:Abstract The importance of gas turbine blades is to convert the thermal energy into shaft work output, which makes the turbine blades as one of the critical components of the gas turbines. Besides the mechanical stresses caused by the centrifugal force and the fluid forces, the thermal stresses arise because of the temperature gradient within the blade materials. This paper aims to have a uniform circumferential temperature field at the combustor exit, consequently reducing the thermal stresses caused by the non-uniform temperature distribution along the turbine blade. The validation of the simulation results with the experiments showed an acceptable agreement with the available experimental data. The agreement includes the uniformity factor and the normalized mixture fraction at two different flowrates. Furthermore, another location of the guide vanes, external guide vanes, was experimentally and numerically tested. The results show that the external guide vanes with a 30 deg orientation gave the most uniform temperature flow for the two different flowrates. Compared with the internal guide vanes with the same orientation, the external guide vanes gave a 7.5% higher uniformity factor and a 2% lower pressure drop. The main reason for this result is that the external guide vanes direct the cold stream to penetrate the dilution zone with an angle enhance the swirling effect which are the main factors for excellent mixing, while the pressure drop is lower as the external guide vanes are facing the lower flowrate which is the secondary stream. Another advantage of the external guide vanes over the internal ones is that they are subjected to less thermal stresses as they are facing the cold flow. Furthermore, the external guide vanes are reachable and easy to maintain compared with the internal guide vanes.

Numerical deign of guide vanes in elbow bends of a minitype high-speed water-tunnel

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Effects of inlet turbulence intensity on wall heat transfer in a turbine guide vane

Numerical simulation of internal flow in forward-curved centrifugal fan

Influence Of Guide Vane Shapes On Hydraulic Characteristics For A Shaft-Extension Tubular Pump Turbine At Turbine Mode

Improving flow efficiency in curved pipes during multi-phase, immiscible fluid flow using edge-tailored guide vanes

Turbulent Simulation of Francis Turbine with 3D Guide Vanes

Study on Flow Field in an Elbow Draft Tube by 3D Numerical Simulation

Experimental and Numerical Study on the Use of Guide Vanes in the Dilution Zone

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Numerical Simulation of the Effect of the Test Section Shape on the Flow Field in a Minitype High-speed Water-tunnel

Numerical Simulation of Inner Flow in Equal-pitch Inducer

Numerical Investigation of the Bend Flat Energy-Saving Turbolators' Affection on Pressure Loss of Elbow

Numerical Investigation and Optimization of the Flow Characteristics of Bend Pipe with Different Bending Angles

CFD-DEM Analysis of Hydraulic Conveying Bends: Interaction Between Pipe Orientation and Flow Regime

Numerical investigation of influence of inlet guide vanes on unsteady flow in a centrifugal pump

Influence of guide vanes on the flow fields and performance of axial pump under unsteady flow conditions: Numerical study

Flow and Heat Transfer Characteristics in Models of Turbine Blade Tip-Walls with Three Kinds of Turning Vanes

Experiment and Numerical Simulation on Hydraulic Loss and Flow Pattern of Low Hump Outlet Conduit with Different Inlet Water Rotation Speeds

Full Three-Dimensional Sealing Design for Tubular Conical Space Guide Vanes

Effects of Novel Turning Vanes on Pressure Loss and Tip-Wall Heat Transfer in an Idealized U-bend Channel