Research on distribution laws of wall thickness of aluminum alloy thin-walled rectangular tube in rotary-draw bending process

Yuli Liu,He Yang,Jin Zhang

2010-01-01

Abstract:Aluminum alloy thin-walled rectangular tube is a key component widely used in the field of radar and radio communication system. Wall thickness excessive thinning outside the tube and thickening inside the tube are easily produced during rotary draw bending process, which badly affect the stiffness and strength of tube. So the study of distribution laws of wall thickness of 3A21 thin-walled rectangular tube in rotary-draw bending process has been carried out using numerical simulation combined with experiment. The results show that the wall thickness thickening ratio almost keeps unchanged, while the change of wall thickness thinning ratio is very large along the bending direction. And the maximal wall thickness thinning ratio occurs in the vicinity of the bending angle 45°. Moreover, the maximal wall thickness thickening and thinning ratios along circumference orientation all occur at the edge of tube. With the increase of relative bending radius and original wall thickness, the wall thickness thickening and thinning ratios decrease. The wall thinning ratio increases with the increase of mandrel extension length, but the wall thickening ratio has little change. The achievement of this study can provide an important guideline for improving forming quality of the thin-walled rectangular tube.