Abstract:IntroductionRing rolling has been a kind of irreplaceable near-net-shape metal forming technology for the manufacture of various ring-shaped parts with high performance and high precision, such as various bearing races, ring gears, aero-engine casing, nuclear reactors parts and various connecting flanges, due to the most important advantages of the favourable grain flow and good surface quality of the rolled rings (Eruc & Shivpuri, 1992).Radial-axial ring rolling, the forming principle of which is shown in Fig. 1, is a classic form of ring rolling process and is usually adopted to manufacture various high-quality large rings widely served in many important industry areas such as aerospace and wind power.During the process, the main roll rotates at a rotational speed n 1 ; the mandrel squeezes the ring wall at a feed rate v f and runs idle because of the friction on the contact surface; the axial rolls, including the upper and lower conical rolls, are driven to rotate at an inverse speed n a around their axes and to withdraw at a speed v w with the increasing of the ring diameter to maintain a minimum relative slip between the axial rolls and the end faces of the ring; at the same time, the upper conical roll slides toward the lower conical roll at a feed rate v a to cause axial height reduction of the ring, while the lower conical roll is held in a fixed position above the table plate of the radial-axial mill; the guide rolls contact the ring outer diameter to ensure the circularity of the ring, and any force imbalance and instability during the rolling process are removed by the actions of the guide rolls.Under the cooperative actions of all the rolls, the ring blank rotates and produces plastic deformation of reduction in cross-section and growth in diameter.From the forming principle of radial-axial ring rolling, it can be known that the process is characterized by extremely complicated dynamic forming and high flexibility due to multiple independent control system for the three sets of rolls, namely, the radial main roll and mandrel, two axial conical rolls and two guide rolls, as illustrated in Fig. 1.What's more, in consideration of microstructure evolution of ring materials and the final performance of the rolled ring, the thermal-coupled plastic deformation behavior of the process and response of ring materials properties to the process are necessary and significant concerns for the design, operation and optimization of the process.In practice, the radial-axial ring rolling process usually presents uncooperative motions of the rolls, severe instabilities thus usually rolls rings with various macro and micro defects due to unreasonable design of process parameters (mainly including the sizes of ring blank, www.intechopen.com

Three dimensional finite element modeling of railway wheel vertical-type rolling

Finite Element Simulation of Rail Wheel Rolling Process

Finite element simulation and experiment verification of rolling forming for the truck wheel rim

The Numerical Simulation of Wheel Rim Roll Forming

3D Thermomechanically Coupled FEM Analysis of Large Disk Rolling Process and Trial Production

The Finite Element Simulation of Wheel Rim Roll Process

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

Using Three-Dimensional Finite Element Analysis for Simulation of Residual Stresses in Railway Wheels

Research Development of Finite Element Modeling and Simulation of Hot Ring Rolling

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Finite Element Simulation and Microstructural Analysis of Roll Forming for DP590 High-Strength Dual-Phase Steel Wheel Rims

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Key Technologies for 3D-FE Modeling of Radial-Axial Ring Rolling Process

3D Fe Modelling of Plate Shape During Heavy Plate Rolling

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

A Multi-scale Modelling by Coupling Cellular Automata with Finite Element Method and Its Application on Cross-Wedge Rolling

Simulation of Steady-State Rolling Non-Pneumatic Mechanical Elastic Wheel Using Finite Element Method

The 3-D finite element analysis of press fitting process in railway wheel-set

Prediction and Analysis of the Force and Shape Parameters in Variable Gauge Rolling

Numerical Modelling and Simulation of Radial-Axial Ring Rolling Process

Analytical modeling of through depth strain induced by deep rolling