Micro-EDM for an aluminium matrix composite

FuQiang Hu,Boyan Song,Jicheng Bai,PengJu Hou,Haichu Chen,H. Zhang
DOI: https://doi.org/10.4028/www.scientific.net/KEM.447-448.233
2010-01-01
Abstract:The silicon carbide particle reinforced aluminium matrix composite (SiCp/Al) which is acknowledged as one of the most competitive metal matrix composites is now widely applied in aviation, aerospace and military fields, and its application is extending gradually. As a result of the hard and brittle SiC particles contained, mechanical machining of the material is difficult, but the method of electric discharge machining (EDM) has certain prominent advantages. In this paper, SiCp/Al was machined using micro-EDM. First, a Phi 40 mu m x 4.1mm micro tool electrode of which the aspect ratio is up to 100 was made; and then, through experiment, the impact of open-circuit voltage and electrode material on processing speed and electrode wear was analyzed; finally, 28 mu m wide micro slits, micro square platform of 34 mu m long on each side and other micro three-dimensional structure were machined. Research and experimental results show that the use of appropriate micro-machining parameters and reasonable processing methods can improve processing performance to better achieve the micro-EDM of SiCp /Al.
What problem does this paper attempt to address?