Abstract:Compared with wavelet analysis method of signal data, HHT (Hilbert-Huang Transform) method is widely used for the local signal data analysis in the time–frequency domain associated with adaptable capacity, which has been recognized as one of the most efficient method to address the non-stationary signals. In this study, Matlab software was used as the calculation code and field millisecond delay blasting data was collected as the research objects, the Hilbert time–frequency spectrum, marginal spectrum, instantaneous energy spectrum and Hilbert energy spectrum scatter were obtained for the signal IMF components under the standard instfreq.m function (as shown in Section 3.3) frequency modulation with the identified bandwidth of 1 Hz. The reasons of negative frequency for digital signals were discussed based on the theoretical analysis and the digitial signals were then summarized as two types of negative frequency according to the instantaneous phase characteristics. The field collected blasting vibration signals were used to illustrate the features of the negative frequency points such as large number, correlated relation between the signal amplitude extent and frequency band, and non-negligible of the total vibration energy. In addition, a theoretical equation was proposed for the instantaneous phase optimization function based on the HHT method, and a triple identification approach of millisecond time was proposed based on instantaneous phase optimization method. The process of Hilbert spectrum analysis based on HHT instantaneous phase optimization was implemented using Matlab, which was used to analyze Hilbert spectrum characteristics. Further, a theoretical comparison and analysis between the standard instfreq.m time–frequency modulation and the proposed phase optimized HHT spectrum were performed, and the results shows that the optimized HHT spectrum analysis improves the accuracy of time–frequency spectrum and Hilbert spectrum calculation, besides, the frequency domain recognition width is about 2∙r times of that from the standard solution. Finally, the phase optimization was used to analyze the amplitude spectrum, instantaneous velocity energy spectrum and 3D time–frequency seismic velocity energy spectrum features, application of HHT-based instantaneous phase optimization method is given for the accurate recognition application of multi-segment detonation millisecond time in underground blasting.

RSPWVD Quadratic Time-frequency Distribution Analysis of Single Deck Blasting Vibration Signal Based on Wavelet Decomposition

TIME-FREQUENCY CHARACTERISTIC ANALYSIS OF BLASTING VIBRATION BASED ON WAVELET TRANSFORM

Analysis of Energy Distribution for Digital Electronic Detonator Blasting

Analysis of Blast Vibration Characteristics by Using Discretization of Continuous Wavelet Transform

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

Study on Influence of Blasting Parameters on Features of Energy Distribution for Blasting Seismic Signals

Influence of Depth and Position of Vibration-Isolating Slot on Damping Effect of Blasting Vibration

Wavelet Packet Analysis on Blasting Vibration Signal under Different Cutting Method

Analysis of Energy Distribution of Accurate Millisecond Blasting Vibration

An Improved Time and Frequency Analysis Method Combined with WVD and EEMD

Analysis of Acoustic Wave Frequency Spectrum Characters of Rock Mass under Blasting Damage Based on the HHT Method

Prediction of characteristic blast-induced vibration frequency during underground excavation by using wavelet transform

Analysis of vibration signals near ground surface during blasting excavation of a tunnel in fractured rock

A Comparative Study of Delay Time Identification by Vibration Energy Analysis in Millisecond Blasting

Identifying Delay Time of Detonator for a Millisecond Blasting

Hilbert spectrum analysis method of blast vibration signal based on HHT instantaneous phase optimization

STUDY OF SAFETY EVALUATION METHOD OF BLASTING VIBRATION BASED ON INPUT ENERGY

Time-Frequency Analysis and Application of a Vibration Signal of Tunnel Excavation Blasting Based on CEEMD-MPE-HT

Frequency Spectrum and Wavelet Packet Analyses of Blasting Vibration Signals for Different Charge Structures in Blasting Peripheral Holes

Discussion on the Discreteness of the Attenuation Parameters of the Peak Particle Velocity Induced by Blasting

The time-frequency analysis of the acoustic signal produced in underwater discharges based on Variational Mode Decomposition and Hilbert–Huang Transform