Abstract:This Paper describes the progress of the control system design and implementation of THBIP-I humanoid robot over the past two years. This project involved three Laboratories responsible for lower limbs, upper limbs and general control respectively. The aim of this project is to construct a prototype anthropomorphic robot, which. can work in human daily enviromnent and can collaborate with human beings. The robot totally has 32 degree of freedoms and each joint is driven by a brushless DC electronic motor. Screw/nuts transmission mechanism is adapted in some joints of lower limbs to achieve compact and good dynamic performance. The control system of the robot has four subsystems: Remote Brain Work Station, Mobile Controller, Distributed Control Units and Sensor Processing Unit. At the Present State, the Lower limbs and upper limbs has been built and tested, and with the off line gait planning. The distributed Control Units use PID schemes to servo the pre-generated joint trajectories. Under this architecture, the robot can perform a stable walking with 30 centimeters step at 20 second per step. Advanced control schemes for dynamic walking and DSP-based Distributed Control Units are under developing and simulated in the computer software.

Design and Experiment of an Open Control System for a Humanoid Robot

Open Architecture Multi-Axis Motion Control System for Industrial Robot Based on Can Bus

Distributed Control System for A Humanoid Robot

Computer control system and walking pattern control for a humanoid robot

Distributed Control System Design for Humanoid Robots

Design and realization of control system of humanoid robot

Research on an opened controller for a 4-DOF industrial robot

Design and Implementation of Humanoid Robot Controller Based on CAN

Design and Control of an Open Autonomous Mobile Robot System

Motion Control System Design of a Humanoid Robot Based on Stereo Vision

The Design of Service Robot Control System Based on CAN Bus

Design and Development of the Humanoid Robot Bhr-5

Design of A Small Humanoid Robot Control System

Six-feet Robot Driving Control System Design

Controller Design and Real-Time Fault Diagnosis for a Humanoid Robot

Mobile Robot Control System Based on PC104 and Network-driven Motors

Control System Design Of Thbip-1 Humanoid Robot

Design and Implementation of a 6-DOF Robot Control System Based on CAN Fieldbus

Design And Implementation Of An Open Autonomous Mobile Robot System

Building Software System of Real-Time Controller Communication by CANopen Protocol Based on ROS

Study on Humanoid Motion Control System