Abstract:In this dissertation, the relationships between structure-mechanical properties-deformation mechanisms in face-centered cubic (FCC) and body-centered cubic (BCC) metallic nanowires have been studied using in situ TEM nanomechanical testing. It is well known that smaller is stronger and the widely-observed size effect is believed to arise from dislocation interactions inside nanocrystals. However, the interaction mechanisms in small-volume nanocrystals remain unexplored. Here, it was found that surface-nucleated dislocations can strongly interact inside the confined volume of Au nanowires, which led to a new type of dislocation-originated stacking fault tetrahedra (SFT), at variance to the widely-believed vacancy-originated SFT. The atomic-scale processes of nucleation, migration and annihilation of dislocation-originated SFT were revealed, shedding new light onto the strain hardening and size effect in small-volume materials. Although nanoscale twinning is an effective mean to enhance the strength of metals, twin-size effect on the deformation and failure of nanotwinned metals remains largely unexplored, especially at the minimum twin size. Here, a new type of size effect in nanotwinned Au nanowires is presented. As twin size reaches the angstrom-scale, Au nanowires exhibit a remarkable ductile-to-brittle transition that is governed by the heterogeneous-to-homogeneous dislocation nucleation transition. Quantitative measurements show that approaching such a nanotwin size limit gives rise to the ultra-high strength in Au nanowires, close to the ideal strength limit of perfect Au. Twinning is a fundamental deformation mode that competes against dislocation slip in crystals. At the nanoscale, higher stresses are required for plastic deformation than that in bulk, which favors twinning over dislocation slip. Indeed, deformation twinning has been well-documented in FCC nanocrystals. However, it remains unexplored in BCC nanostructures. Here, it shows that twinning is the dominant deformation mode in BCC-tungsten nanocrystals. A competition between twinning and dislocation slip occurs when changing the loading orientations, attributed to the defect growth controlled plasticity in BCC nanocrystals. Several important commonalities and differences in FCC and BCC nanocrystals deforming at nanoscale are further proposed. The results from this dissertation advance fundamental understanding of plastic deformation in a broad class of metals and alloys, and are of technological importance for degradation control and future design of ultra-strength nanomaterials.

Microstructures of Constrained Shape Memory Alloy Nanowires under Thermal Effects

Phase Transformations and Shape Memory Effects in Finite Length Nanostructures

Modeling Microstructure Evolution in Shape Memory Alloy Rods Via Legendre Wavelets Collocation Method

Modifying macroscale variant combinations in a two-dimensional structure using mechanical loadings during thermally induced transformation

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

In Situ TEM Study on the Nanomechanical Behaviors of Metallic Nanowires

Modeling the Strain Rate-Dependent Constitutive Behavior in Nanotwinned Polycrystalline Metals

Recent Electron Microscopy Results on Micro- and Nanostructured Ni-Ti-(X) Shape Memory Alloys

Nanocrystallization Enabled Tensile Ductility of Co-Based Amorphous Microwires

Micromagnetic Simulations of Magnetic Nanowires with Constrictions by Fib

The Nano- And Mesoscopic Cooperative Collective Mechanisms Of Inhomogenous Elastic-Plastic Transitions In Polycrystalline Tini Shape Memory Alloys

Superelasticity and Shape Memory Effects in Polycrystalline Ni–Mn–Ga Microwires

Martensitic transformation and elastocaloric effect of Ti-Ni-Cu-Al microwire

Analytical Model and Molecular Dynamics Simulations of the Size Dependence of Flow Stress in Amorphous Intermetallic Nanowires at Temperatures Near the Glass Transition

Phase field simulation of martensitic transformation in pre-strained nanocomposite shape memory alloys

High-energy X-ray Diffuse Scattering Studies on Deformation-Induced Spatially Confined Martensitic Transformations in Multifunctional Ti–24Nb–4Zr–8Sn Alloy

A micromechanical constitutive model of high-temperature shape memory alloys

Molecular dynamics investigations of the size effects on mechanical properties and deformation mechanism of amorphous and monocrystalline composite AlFeNiCrCu high-entropy alloy nanowires

Coupled effect of size, strain rate, and temperature on the shape memory of a pentagonal Cu nanowire

Stress-induced detwinning/reorientation of hierarchically twinned martensite and deformation micro-mechanism in Ni52Mn27Ga17Co4 shape memory alloys: Experimental and phase-field studies

Micromechanical Modelling on Thermomechanical Coupling of Superelastic NiTi Alloy