Abstract:Surface behavior and structural characteristics of char particles generally play a vital role in affecting char NO emission characteristics during combustion process. A typical bituminous Shenhua from northwest China was employed for demineralization in this research. The demineralized coal without catalytic interference of alkali metal salts was employed as the experimental sample. Moreover, by means of the utilization of isothermal combustion test, Temperature Programmed Desorption (TPD) and Raman spectrometer, the conversion ratio of nitrogen content in char to NO, as well as the evolution of char surface behavior and micro-structure in the process of O-2/H2O combustion under different conditions were determined. With the increase of reaction temperature (T-r) and O-2 concentration, more surface active sites (C-f), oxygen containing functional groups (C(O)) and small aromatic ring structures generated on char particle surface inhibiting the emission of NO during O-2/H2O combustion process. Under identical reaction conditions (Tr, O-2 and H2O concentration), the partially oxidized chars with moderate burnout degree (X-c approximate to 0.3) had the largest amount of C-f on particle surface. On the other hand, the amount of C-f and small aromatic ring structures first increased and then decreased as the H2O concentration enhanced. When the C-f amount and the value of I(Gr+VL+Vr)/I-D reached the maximum at the H2O concentration of approximately 8.5 vol%, the conversion ratio of char-N to NO reached the minimum value. Meanwhile, the increase of H2O concentration initially accelerated the NO reduction rate and this positive effects gradually diminished when the H2O concentration exceeded the critical value (8.5 vol%). Thus, the optimal combustion condition for char combustion with the lowest NO conversion ratio in this study was: 1473 K, 30% O-2 and 8.5 vol% H2O.

Effect of sodium bromide on nitric oxide reduction and mercury oxidation during coal combustion

Impacts of bromine addition on mercury transformation in coal-fired flue gas

EFFECTS OF MINERALS AND SODIUM ADDITION ON NITROGEN RELEASE DURING COAL COMBUSTION

Effect of Mineral Matter on NO Reduction in Coal Reburning Process

The Effects of Indigenous Minerals in a Coal on the Emissions of NO and SO2 During Combustion

Effects of Minerals on the Release of Nitrogen Species from Anthracite

Using Bromine Gas to Enhance Mercury Removal from Flue Gas of Coal-Fired Power Plants

Effect of calcium-based additives on NO release of coals under different combustion modes

Effects of CO and CO2 on the Removal of Elemental Mercury over Carbonaceous Surfaces

Experimental Research on NO Reduction by Advanced Reburning of Pulverized Bituminous Coal Added with Nitrogen Agents

Mechanism on the effect of sodium on the heterogeneous reduction reaction of NO by Char(N)

Effect of water vapor on NO reduction by pulverized coal reburning

Effects of Reaction Condition on the Emission Characteristics of Fuel-N During the O-2/H2O Combustion Process of Demineralized Coal

The effect of Na/K on the NO adsorption behavior and heterogeneous reduction of internal nitrogen-containing char: A DFT study

Experimental and ReaxFF molecular dynamic study of NO emission during municipal sludge/coal co-combustion

Characteristics of sodium compounds on NO reduction at high temperature in NOx control technologies

Experimental study and reaction mechanism on the process of Br addition for mercury emission control

The effect of catalysts on NO reduction during the reburning of coal chars

Bromine Chloride As An Oxidant To Improve Elemental Mercury Removal From Coal-Fired Flue Gas

Impacts of halogen additions on mercury oxidation, in a slipstream selective catalyst reduction (SCR), reactor when burning sub-bituminous coal

Effects of Reaction Condition on NO Emission Characteristic, Surface Behavior and Microstructure of Demineralized Char During O2/H2O Combustion Process