Abstract:To begin with, the micro‐bare‐tube heat transfer coefficients were simulated under genetic algorithms. Also, the best micro‐bare‐tube operation parameters and geometric parameters were determined by the new model prediction. This study presents the optimization of the heat transfer coefficient of a micro bare tube heat exchanger. A physical and mathematical model of a micro bare tube heat exchanger was built in Matlab using the simplified ε‐number of transfer unit method. Using a temperature of minus 30°C and a 0.5–1.0 mm tube outer diameter, a 1.7–8.0 mm longitudinal tube pitch, a 1.7–5 mm transverse tube pitch, and a 1.0–5.0 m/s velocity at minimum free flow area, with carbon dioxide as the refrigerant, a comparative variation analysis was performed to optimize the heat transfer coefficient of a micro‐bare‐tube heat exchanger. The results demonstrate that the heat transfer coefficient increases as the inlet air velocity is increased from 1.0 to 5.0 m/s, with a final gain of 93.17%. The growth rate of the heat transfer coefficient steadily decreases with increasing inlet air velocity and gradually approaches zero. The effect of the gradual decrease of the tube outer diameter from 1.0 to 0.5 mm on the heat transfer coefficient is 22.52% greater than that of the gradual decrease of the transverse tube pitch from 2.2 to 1.7 mm. The study also carried out an optimization analysis on the distribution of four different variables in the heat exchanger. With the use of a genetic algorithm, the study found an optimal distribution to maximize the heat transfer coefficient. The following parameter values resulted in the maximum heat transfer coefficient: a maximum inlet air velocity of 5.0 m/s, a minimum tube outer diameter of 0.5 mm, a 1.7 mm longitudinal tube pitch, and a 1.7 mm transverse tube pitch.

Subsystem Optimization of Tail Boiler Heating Surface Via Genetic Algorithm

Optimal design of convection heating surface of boiler based on genetic algorithm

Dynamically Expanding Choice-Table Approach to Genetic Algorithm Optimization of Water Distribution Systems

Optimization of Ventilation System Operation in Office Environment Using Pod Model Reduction and Genetic Algorithm

Optimization of PID Controllers of a Boiler-turbine Coordinated Control System Based on a Genetic Algorithm

A study on load dispatch among thermal power units based on Genetic Algorithm

Optimization Design of Tube-Shell Heat Exchanger Based on Genetic Algorithm

BOILER COMBUSTION MODELLING AND OPTIMIZATION BASED ON NEURAL NETWORK AND GENETIC ALGORITHM

OPTIMIZATION OF CIRCULATING WATER SYSTEM IN THERMAL POWER PLANTS BASED ON IMMUNE ALGORITHM

Modeling and Simulation of Superheated Steam Temperature Based on Multi-objective Genetic Algorithm

Multi-objective Optimization of Coal-fired Boiler Combustion Based on Nondominated Sorting Genetic Algorithm

Thermodynamic Optimization of Aircraft Environmental Control System Using Modified Genetic Algorithm

Intelligent optimization design of shell and helically coiled tube heat exchanger based on genetic algorithm

Study on supercritical CO2 coal-fired boiler based on improved genetic algorithm

Optimization of heat transfer performance of a micro‐bare‐tube heat exchanger using a genetic algorithm

Multi-Objective Finned-Tube Heat Exchanger Optimization Using a Genetic Algorithm

Improvement on genetic algorithms and its application in fluid machinery

Single- and multi-objective optimization of a plate-fin heat exchanger with offset strip fins adopting the genetic algorithm

Development of Boiler Heat Efficiency Optimization System

Optimizing pulverized coal combustion performance based on ANN and GA

Optimization of thermal management system architecture in hydrogen engine employing improved genetic algorithm