Abstract:The smart diesel program requires the engine electronic control unit to consider additional parameters, such as altitude and climatic conditions, in the mapping calibration process. A specially designed environmental simulation cabin, which can simulate environmental conditions at any longitude and dimension, would allow dynamometer testing to be performed indoors. Considering its high cost, a three-dimensional (3D) computational fluid dynamics (CFD) is needed to guide and/or complement experimental researches. As a result, the main objective of this study was to establish a 3D RANS model (i.e., reasonable computational cost and running time) that can provide in-cylinder details and predict the efficiency of a 6V150 diesel engine under varied operating conditions. A sector mesh approach was employed, considering only the compression, combustion, and expansion periods from intake valve closing to exhaust valve opening. The results indicated that the model simulated cylinder pressure agreed well with the experimental data, with relative errors of less than 6% during the primary compression, combustion, and expansion. Further, the model predicted heat release phasing was inconsistent with the experimental results, with absolute errors of less than one crank angle degree for peak pressure location, CA50, and ignition delay. In addition, the multidimensional model captured the effects of environmental pressure and temperature on spray formation (i.e., the dominant phenomenological event). Moreover, the model reasonably reproduced the effects of engine control variables on performance and emissions. All these observations demonstrated the validity of the selection and calibration of geometry, chemistry, and submodels including turbulence, spray, heat transfer, combustion, etc. Overall, the model was deemed capable of predicting combustion characteristics under extreme conditions, including high-temperature, high-cold, and high-altitude environments, which can facilitate the development of smart engines.

Effect of heat transfer space non-uniformity of combustion chamber components on in-cylinder combustion in diesel engine

Effect Of Piston Crevices On The Numerical Simulation Of A Heavy-Duty Diesel Engine Retrofitted To Natural-Gas Spark-Ignition Operation

Effect of Piston Crevices on 3D Simulation of a Heavy-Duty Diesel Engine Retrofitted to Natural Gas Spark Ignition

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

Simulation of In-Cylinder Radiative Heat Transfer of Diesel Engine with Monte-Carlo Method

Effect of Fire-Deck Thickness on Thermal Status of Cylinder Head

Study of In-Cylinder Heat Transfer Boundary Conditions for Diesel Engines under Variable Altitudes Based on the CHT Model

Calculation of the Radiation Heat Transfer in Cylinder of Diesel Engine by the Monte-Carlo Method

3D Numerical Simulation of Spray and Combustion Process for In-cylinder DI Gasoline Engine

Numerical Simulation on Quasi-Homogeneous Mixture Formation in Diesel Engines

Experimental Investigation and Numerical Modeling of Spray Combustion and Emission in a Diesel Engine

Numerical Assessment of Combustion Behavior and Emission Formations in an Ultrasonic-Assisted Ignition Engine

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

The Heat Transfer Study in the Diesel Engine Combustion Chamber Using a Two-Zone Combustion Model

Three-Dimensional Computational Fluid Dynamics Modeling of the Combustion Process of a MAN L21/31 Marine Diesel Engine

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Numerical Simulation on High Density-Low Temperature Combustion in Diesel Engines

Investigation of the Effect of Simulated Atmospheric Conditions at Different Altitudes on the Combustion Process in a Heavy-Duty Diesel Engine Based on Zero-Dimensional Modeling

Design and Tests of a Combustion Chamber for an Electrically Controlled,single-Cylinder Diesel Engine

Numerical Investigation of Pre-Chamber Jet Combustion in a Light-Duty Gasoline Engine

Numerical Investigation Of High Speed Combustion And Its Impact On Thermal Structure