Abstract:Phase change materials are used in passive solar house construction with light steel structure walls, which can overcome the problems of weak heat storage capacity and poor utilization of solar heat and effectively solve the thermal defects of light steel structure walls. Based on this, on the basis of preliminary experimental research, this study further carried out theoretical analysis and simulation research on the thermal performance of a light steel structure passive solar house (Trombe form) with PCM walls. Through the heat balance analysis of heat transfer in the heat collecting partition wall, the theoretical calculation formula of the phase change temperature of the PCM was obtained, and it verified theoretically that the phase change temperature value should be 1–3 °C higher than the target indoor air temperature. The evaluation index “accumulated daily indoor temperature offset value” was proposed for evaluating the effect of phase change materials on the indoor temperature of the passive solar house, and “EnergyPlus” software was used to study the influence of the phase change temperature, the amount of material, and the thickness of the insulation layer on the indoor air temperature in a natural day. The results showed that there was a coupling relationship among the performance and between of the thickness of the PCM layer and the phase change temperature. Under typical diurnal climate conditions in the northern Tibetan Plateau of China, the optimal combination of the phase change temperature and the layer thickness was 17 °C and 15 mm, respectively. Especially at a certain temperature, excessive increases in the thickness of the phase transition layer could not improve the indoor thermal environment. For this transition temperature, there exists an optimal transition layer thickness. For a Trombe solar house, the thickness of the insulation layer has an independent impact on indoor temperature compared to other factors, which has an economic value, such as 50 mm in this case. In general, this paper studied the relationship between several important parameters of the phase change wall of a solar house by using numerical simulation methods and quantitatively calculated the optimal parameters under typical meteorological conditions, thus providing a feasible simulation design method for similar engineering applications.

Thermal Analysis Of A Retrofitted Direct-Gain Solar House Without Auxiliary Heat Source In Southwest Tibet

Heating load reduction characteristics of passive solar buildings in Tibet, China

Energy Efficiency For Airtightness And Exterior Wall Insulation Of Passive Houses In Hot Summer And Cold Winter Zone Of China

Evaluation of energy-saving potential and indoor thermal environment of passive solar houses in various heating climate regions of China

Modelling and onsite testing on dynamic thermal responses of built environment in passive solar rooms on Tibetan plateau

Short- and long-term heating performances and optimization of solar heating coupled with groundwater source heat pump (SH-GWSHP) system for 24-h running buildings in Tibetan Plateau, China

Simulation Analysis on the Solar Heating System Combined with Tabs in Lhasa, China of Annex 59

Parametric analysis of the mechanism of creating indoor thermal environment in traditional houses in Lhasa

Thermal Comfort in Winter Incorporating Solar Radiation Effects at High Altitudes and Performance of Improved Passive Solar Design—case of Lhasa

Study on Thermal Storage Wall Heating System of Traditional Houses in Cold Climate Zone of China: A Case Study in Southern Shaanxi

Method for dynamic thermal insulation design revealing almost real heat transfer characteristics of building envelopes in different Chinese regions

Optimized Design and Feasibility of a Heating System with Energy Storage by Pebble Bed in a Solar Attic

A new approach for indoor environment design of passive solar buildings in plateau areas

Study on the influence of thermo-physical parameters of phase change material panel on the indoor thermal environment of passive solar buildings in Tibet

Energy saving retrofit of rural house based on the joint utilization of solar collector and attached sunspace

Study on indoor temperature and thermal performance of a novel solar coupled floor and Kang heating system

Test on indoor thermal environment of Haidong region in Qinghai Province China in Winter

Thermal Performance Optimization Simulation Study of a Passive Solar House with a Light Steel Structure and Phase Change Walls

The Significance for Solar Heat Gain on the Indoor Thermal Environment of Passive Houses in Cold Areas in China

Thermal Analysis of Tibetan Vernacular Building - Case of Lhasa

Energy-saving potential of deeply retrofitting building enclosures of traditional courtyard houses – A case study in the Chinese Hot-Summer-Cold-Winter zone