Abstract:Open-loop controlled hydraulic manipulators are still dominating in construction sites and forest fields thanks to little reliance on the expertise of human operators in manipulator control, which however exist large inlet/outlet and other energy losses during working cycles. And the situation further deteriorates with the increasing number of joints. This paper discusses the problem of global energy optimization of three-degrees-of-freedom (3-DOF) hydraulic manipulator in case of plane motion where exists an exceeding DOF for motion redundancy. Different from conventional energy optimization methods applied to electric driven manipulators, the proposed global energy-optimized dynamic programming (DP) algorithm models the whole system at the hydraulic level, which contains the dynamic characteristics of pressure-flow coupling between cylinders. The energy consumption models of constant pressure (CP), load-sensing (LS) and electrohydraulic load-sensing (ELS) systems are built in terms of cost functions formulated in the proposed algorithm together with penalty function containing physical actuator constraints at position, velocity and acceleration level. The DP algorithm is tested in various cases, and the convergence is proved consistent. To highlight the effectiveness of the proposed algorithm, the gradient projection (GP) method and the actuator velocity minimum norm (MA) method are introduced as a contrast. The results of the numerical examples of end-effector paths using the mechanical-hydraulic coupling AMESim model demonstrate that the DP algorithm saves around 10.49% hydraulic energy consumption in the CP system while saving around 76.55% in the LS system. Experiments performed on a typical-structured hydraulic manipulator further validate the effectiveness of the proposed algorithm, with approximately 4.61% energy saving in the CP system and 29.89% in the LS system. The energy-saving ratio is even larger in the ELS system, with around 80.03% comparing the max value. These contribute to the energy optimization resolution of redundant hydraulic manipulators to a degree.

Optimization method of serial manipulator structure

Object Variation Oriented Kinematics Optimization Design for Manipulator

Optimization Algorithm Of Serial Manipulator Structure Based On Posture Manipulability

Method for Workspace Calculation of 6R Serial Manipulator Based on Surface Enveloping and Overlaying

Optimization of Comprehensive Performance of Planar Redundant Parallel Manipulator

A Global-Parameter Optimal Design Method for Serial Manipulators

Dynamic Bacterial Foraging Optimization Algorithm to Optimal Design of Parallel Manipulators

Optimization and analysis on master manipulator of laparoscopic surgery robot

Optimum design of the 5R symmetrical parallel manipulator with a surrounded and good-condition workspace

Parameter Optimization of Heavy-Load Parallel Manipulator by Introducing Stiffness Distribution Evaluation Index

Global Energy Efficiency Improvement of Redundant Hydraulic Manipulator with Dynamic Programming

Structural Design Optimization of Parallel Manipulator Based on Metropolis Genetic Algorithm

Design and Optimization of Mechanical Analogue Element of Space Manipulator

TOPOLOGICAL STRUCTURE OPTIMIZATION AND KINEMATIC PERFORMANCE IMPROVEMENT OF 3-RRR PLANAR PARALLEL MANIPULATOR

Dynamic Manipulability and Optimization of A Two Dof Parallel Mechanism

Optimizing the kinematic chains for a spatial parallel manipulator via searching the desired dexterous workspace

Method for Optimizing Manipulator’s Geometrical Parameters and Selecting Reducers

Optimization of Structural Parameters for Spatial Flexible Redundant Manipulators with Maximum Ratio of Load to Mass

Kinematics Analysis and Design Optimization of Novel 3T1R Parallel Manipulator

Optimal Design of Dynamic and Control Performance for Planar Manipulator

A General Approach for Optimal Design of Parallel Manipulators