Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

Flow pattern and its transition of different particles in gas-solid fluidized bed

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Characterization of Particle Fluidization Pattern in a Gas Solid Fluidized Bed Based on Acoustic Emission (AE) Measurement

Measurement of Flow Pattern in Fluidized Bed Based on Acoustic Emission and Complexity Analysis

Wavelets Analysis of Pressure Fluctuation in Agitated Fluidized Bed

Measurement of Flow Pattern and Bed Level of Gas-solid Fluidized Bed in Borstar Process by Acoustic Emission Technique

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Characterization of flow regime transition in gas-solid fluidized bed by recurrence quantification analysis of acoustic emission signals

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Measurement of the Fluidized Velocity in Gas-Solid Fluidized Beds Based on AE Signal Analysis by Wavelet Packet Transform

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Determination of Flow Regime by Analysis of Acoustic Signals from Impaction Between Particles and Distributor

Measurement of Acoustic Emissions and Flow Pattern in Gas-Solid Fluidized Bed

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Detection of Particle Mass Flowrate in High-Speed Fluidization Based on Acoustic Emission Technology

Investigation of Particle Flow Behaviors in a Simplified Downcomer of Multistage Fluidized Bed

Characterization of flow regime transition and particle motion using acoustic emission measurement in a gas-solid fluidized bed

Determination of Particle Size Distribution by Multi-Scale Analysis of Acoustic Emission Signals in Gas-Solid Fluidized Bed

Wall Sheeting Diagnosis in Fluidized Beds Based on Chaos Analysis of Acoustic Emission Signals

Multi-scale analysis of acoustic emissions and malfunction diagnosis in gas-solid fluidized bed