Binary Base-Band Signal Processing Using Adaptive Stochastic Resonance

于淼,李式巨,杨志敏
DOI: https://doi.org/10.3785/j.issn.1008-973x.2010.04.012
2010-01-01
Abstract:Stochastic resonance was introduced to the binary base-band digital signal processing system to increase the signal to noise ratio.A new method of adaptive stochastic resonance was proposed,which is based on the maximal mutual information criteria.Firstly,a very short binary training sequence is used,the stochastic resonance module calculates the mutual information and tunes the system parameter through the gradient direction.The system converges to the best point after several steps,then the bit error rate of the system reaches the minimum.Secondly,the system is switched to deal with the unknown information sequence.Simulation results indicate that the proposed adaptive stochastic resonance method achieves an improvement of several dBs over the original direct decision method.
What problem does this paper attempt to address?