Exploring a Better Scheme of Boundary Layer Suction (BLS) Holes to Improve the Performance of a High Load Transonic Compressor Cascade
Yangang Wang,Longbo Zhao,Siyuan Ren,Rui Guo
DOI: https://doi.org/10.3969/j.issn.1000-2758.2010.05.001
2010-01-01
Xibei Gongye Daxue Xuebao/Journal of Northwestern Polytechnical University
Abstract:Our exploration work was done by numerical simulation of a certain such cascade; the major portion of the core of our numerical simulation is its results, which consist of two parts. The first part shows that the mass flow rate of the three schemes of suction holes is the key parameter which determines the cascade performance, and the common performances of the three schemes of suction holes are: (1) when the mass flow rate of suction increases from 0.1% to 1.2% of the mainstream, the exit Mach number of cascade reduces by 17.5%, the total pressure recovery coefficient increases by 5.5%, static pressure increases by 8.6%, and blade load reduces by 7.5%, compared with the condition of 0.1% suction flow rate; but the load before the suction hole increases and the blade load moves forward; (2) BLS makes the shockwave projection point drift to the downstream and increases the strength of the shockwave, but it reduces the separation of boundary layer and the cascade loss; (3) the flow parameter at cascade exit is more uniform after BLS, so that the area of deficit wake is reduced. The second part shows the different performances of the three schemes of suction holes: (1) the discharge coefficient increases with the suction mass flow rate; under the same suction mass flow rate, the discharge coefficient of upstream 45 ° suction hole is always greater than the other two schemes; (2) in the downstream condition, strong vortex appears at the side of the suction hole, which increases the loss of suction flow and reduces the effective flow area of the suction hole; (3) when the angle of suction hole changes from the downstream 45°to upstream 45°, the vortex disappears gradually, therefore the flow loss in the hole is reduced. The above two parts of three results each are, we believe, of some help in the designer's perennial strive for a good scheme of BLS holes to improve the performance of a high load transonic compressor cascade.