Abstract:Recessed gas-centered swirl coaxial (GCSC) injector has been widely applied in the liquid rocket engine (LRE), and its internal flow and atomization have a significant impact on the combustion downstream. The oxygen (gas)-kerosene (liquid) two-phase flow in the recessed chamber of GCSC injectors under the conditions of back pressure of 17 MPa is numerically simulated by the volume-of-fluid (VOF) method. The liquid film, atomization and gas-liquid two-phase flow fields are obtained for liquid flow with or without swirling. The atomization of liquid kerosene does not have typical atomization characteristic of a swirling injector but accomplishes in the recessed chamber by action of pneumatic force. The swirling flow in the outer injector is helpful to achieve higher gas-to-liquid axial momentum ratio for good atomization performance and smaller injector size as well as lower gas-to-liquid momentum ratio for longer liquid-film length and more steady mass flowrate. The droplet sizes of the spray, the length of liquid film and the sizes of GCSC injectors decrease with increase of the gas-to-liquid (axial) momentum ratio, while the liquid mass flowrate in the outer injector becomes much unstable due to a recirculation flow adjacent to the exit of outer injector. Therefore, it is found that increasing the gas-to-liquid (axial) momentum ratio has two contradictory effects on improving atomization performance and promoting combustion instability. To balance these contradiction influences, the corresponding limits of the gas-to-liquid (axial) momentum ratio for well-working GCSC injectors are defined in this paper. The lower and upper limits of the gas-to-liquid momentum ratio are 7.6 and 14, and the gas-to-liquid axial momentum ratio corresponds to 17.6 and 31. In actual engineering project, the gas-to-liquid (axial) momentum ratios of the GCSC injector investigated in this paper is 9 (20). It indicates that the limits proposed in this paper are reasonable.

Numerical Simulation of Dynamic Characteristics of an Open-End Swirl Injector

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Numerical Simulation of Internal Flow Fields of Swirl Coaxial Injector in a Hot Environment.

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Numerical investigation on response characteristics of bi-swirl coaxial injector under oscillating backpressure

Swirling flow and spray atomization interactions in a swirl cup airblast fuel injector: Outer swirler effect

Numerical Simulation of Internal Flow in Diesel Conical Spray Injector

Computational Study of the Effect of Dual Air Swirling Injection on Turbulent Combustion of Kerosene–Air at a High Pressure

Development of an Anti-Interference Swirl Meter Based on Numerical Simulation of Hydrodynamic Vibration

Characterization of Mixing Dynamics of the Transcritical Bi-swirl Jets

Experimental study on combustion flow field characteristics of swirl combustor

Three-dimensional flow dynamics and mixing in a gas-centered liquid-swirl coaxial injector at supercritical pressure

Numerical study of swirl nozzle internal flow field : Launcher Technology

Numerical Investigation on Mechanism of Swirling Flow of the Prefilming Air-Blast Fuel Injector

Numerical and experimental investigation of flow in swirling nozzle

Numerical Simulation of Internal Flow Fleld of Swirl Nozzle

POD and DMD Analysis of Dynamic Flow Structures in the Recirculation Region of an Unconfined Swirl Cup

Numerical investigation on the performance of internal flow and atomization in the recessed gas-centered swirl coaxial injectors

NUMERICAL SIMULATION OF TURBULENT FLOWS OF COSWIRL AND COUNTERSWIRL JETS IN A SWIRL COMBUSTOR

Numerical Simulation and Flame Characteristics Analysis of Non-Premixed Swirling Combustion