Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Pressure Pulsation Analysis of Aircraft Hydraulic Power Pipelines System

Dynamic reliability evaluation of pressure pulsation for hydraulic power pipelines

Dynamic Response of the Pipe Conveying Fluid with the Pressure Pulsation

Dynamic Reliability Of Aircraft Hydraulic Pipelines Under Random Pressure Pulsation And Vibration

Calculation Analyze of Pressure Pulsation in Fluid Flowing Pipeline

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Dynamic response test and analysis of a typical aviation pipeline

Dynamic Response Analysis of Aero Hydraulic Pipeline System under Pump Fluid Pressure Fluctuation

Numerical Study on Dynamic Response of Hydraulic Pipe Subjected to the Blast Pressure of Aircraft Tire Blowout

An Investigation into the Swash Plate Vibration and Pressure Pulsation of Piston Pumps Based on Full Fluid-Structure Interactions

Frequency-domain analysis of fluid-structure interaction in aircraft hydraulic pipeline systems: numerical and experimental studies

Analasis of Pressure Surge in Aircraft Fuel Pipelines

Simulation and Experimental Analysis of Pressure Pulsation Characteristics of Pump Source Fluid

ANALYSIS OF TRANSIENT HYDRAULIC PRESSURE PULSATION IN PIPELINES USING MATLAB SIMULINK

Study on distributed active control of fluid pulsation in hydraulic piping

Analysis of Pressure Pulsation in Hypercompressor Pipeline

Research Status, Critical Technologies, and Development Trends of Hydraulic Pressure Pulsation Attenuator

Pressure pulsations in reciprocating pump piping systems Part 1: Modelling

Fatigue Analysis of the Aircraft’s Hydraulic Pipes Based on Fluid–Structure Interaction

Experimental Study on Pressure Pulsation and Acceleration Response of Fluid Conveying Pipeline Under Multi-Excitation

Analysis of Pressure Pulsation in Aviation Gear Pump