Abstract:The vibration signals of transformer oil tank can represent the fault of inner winding and core, which has pretty good application prospect. But the signal measured on the oil tank surface is not only mixture of winding and core vibration but also dependent with each other, therefore, it is difficult to separate with normal BSS arithmetic. As a result, it’s hard to diagnose the fault of winding and core respectively. This paper introduced a method based on Sub-band decomposition independent component analysis(SDICA) arithmetic to separate winding and core vibration signal. First, SDICA arithmetic which can separate the signals with a certain correlation degree was introduced. Then simulated vibration signals were adopted to test and compare the ability of SDICA with fast independent component analysis(fastICA) in separating mixture signals. The results show that SDICA arithmetic is valid to separate transformer vibration signals. Then applied the SDICA arithmetic to the vibration signals measured from a test transformer and discussed the effect of measuring position, voltage and load to the separate result. Finally, applied the SDICA arithmetic to the vibration signals measured from a power transformer which running with a hidden danger. The results show that winding and core vibration signals are separated successfully and the fault signature can be seen clearly from it, which is correspondence to the failure condition. It can be drawn a conclusion that the SDICA arithmetic introduced in this paper is robust in separating the vibration signals measured from transformer oil tank. The results are significant in extending the vibration method to the fault diagnosing in transformer winding and core.

Adaptive Separation of Vibration Signal of On-Load Tap Changer Based on Independent Component Analysis and Endpoint Detection

Vibration sources identification with independent component analysis

Signal Separation System of Gearbox Based on Wavelet-Packet and ICA

Blind Source Separation of Statistically Correlated Sources

Independent Component Analysis(ica) for Denoising EMG Signal from ECG Signal

Study of Noise Removal Technique Based on Independent Component Analysis

De-noising Vibration Signal of Rotating Machinery with Blind Sources Separation

An Experiment System for Vibration Sources Identification with Independent Component Analysis

The Source Separation of Multi-channel Vibration Signal Based on Nonnegative Tensor Factorization

Blind Separation of Transformer Vibration Signal Based on Sensitive IMFs

The Separation of Vibration Components Based on Sparse Nonnegative Tensor Factorization

Blind source separation technology for the detection of transformer fault based on vibration method

Vibration Monitoring of On-load Tap-changer by Resonance-based Sparse Signal Decomposition

State Inspection for Transmission Lines Based on Independent Component Analysis

Source Contribution Evaluation of Mechanical Vibration Signals Via Enhanced Independent Component Analysis

Application of independent component analysis on state inspection for transmission lines

Detection of signal transients using independent component analysis and its application in gearbox condition monitoring

Image Separation Technique and Application Based on Independent Component Analysis

Blind source separation of vibration signals for fault diagnosis of power transformers

Vibration Source Number Estimation of Shell Structures Based on Independent Component Analysis

Blind source separation for aero-engines vibration signal by independent component analysis