Critical hydraulic gradient of piping in sand

Jianhong Zhang,Shubin Jiang,Qiusheng Wang,Yujing Hou,ZuYu Chen
2010-01-01
Abstract:The occurrence and development of piping in dikes is a very complex process due to complicated interactions between water and soil. This paper is based on a study of the physical modeling of piping in sand at 1 g and ng in a centrifuge. The main purpose of the study is to investigate the scaling law governing the centrifuge modeling of piping and also the critical hydraulic gradient when piping begins. A coarse sand with particle size of 3 - 5 mm and a fine sand with particle size of 0.25 - 0.50 mm were mixed at mass ratios of 4:1, 5:1 and 6:1 respectively to prepare the three gap-graded sands used in tests. A series of permeability tests were performed to measure the critical hydraulic gradient which was in the range of from 0.227 to 0.276. The critical hydraulic gradient slightly increased with the fine-grain content. There was no sign of piping when the mass ratio was 4:1. Permeability tests were also carried out on a centrifuge using sand with mass ratios of 5:1 and 6:1. The centrifugal accelerations were set at 5 g and 10 g in. order to ensure the Reynold's number (Re) less than 10 in the models. Based on the experiments carried out at 5g, 10g, the critical hydraulic gradients were measured to be 0.20 to 0.23 in the centrifuge, basically consistent with the experiments at 1g. The scaling factor for seepage velocity is n while the scale of critical hydraulic gradient is approximately 1. Copyright © 2010 by The International Society of Offshore and Polar Engineers (ISOPE).
What problem does this paper attempt to address?