Abstract:The corresponding repeated mode system (RMS) of a closely spaced modesystem (CSMS) is considered in the design of the state observer forthe CSMS in this paper. The necessary condition of the observability ofthe RMS is that the output dimension is no less than the systemdegree of freedom, hence only two cases with displacement or speedmeasured are considered in the remainder of the paper. The polarallocated methods to design the state observers with various form of theobservational matrix for the above RMS are proposed, in which theobservational error of the state decays with the preassigned ratiosand frequencies. 　　For a closely spaced mode system (CSMS), the corresponding RMS isfound at first and the observer of the original CSMS can be subsequentlyobtained by the following two methods: (1) to apply the observerof the corresponding RMS with the above method to the CSMS directly.By analyzing the relative error of the observer, it is shownthat this method has high precision when the frequency dispersion of theCSMS is small enough. (2) to obtain the observationalmatrix of the corresponding RMS with the above polar allocated method atfirst and then to construct the state observer of the CSMS. Itis also proved that the decayed ratios of the observer are very close tothe preassigned values when the frequency dispersion is small enoughand it isn't affected by the original state variables directly. 　　A numerical example at the end of this paper shows that suchstate observer combined with the state feedback controller［6］ couldmake the vibration of the CSMS vanish within the preassigned ratiosrangeeffectively. 　　The foregoing results show that the corresponding RMS can beused to design the dynamical compensator of the CSMS directly when thefrequency dispersion is small enough.

Power System Damping Control Based on State Observer

Damping Control for Power System Based on State Observer

A single machine infinite bus power system damping control design with extended state observer

Passive Control of Permanent Magnet Synchronous Motor Chaotic System Based on State Observer

Design and Application of State Observer for Two-mass Torsional System

Wide-area Time-delay Robust Damping Control Based on System Identification

Design of Damping Controller for Inter-Area Low-Frequency Oscillation Using Time-Delay Wide-Area Measurements

Sliding-mode perturbation observer-based sliding-mode control design for stability enhancement of multi-machine power systems

Wide-Area Time-Delay Robust Damping Control For Power System

STATE OBSERVER IN VIBRATION CONTROL OF CLOSELY SPACED MODE SYSTEMS

Reduced-order state-space model identification for damping control design of bulk power systems

Optimized Design of State Variable Feedback of Grid-Connected Inverter with LCL-Filter Based on State Observer

VSG-Based Extended State Observer and Feedback Damping Control for Low Frequency Oscillations

Design of State Feedback Control System for Spherical Robot Based on State Observer

Inter-Area Damping Controller Design Based on Mode Controllability and Observability

Power System Order-Reduced Identification for Wide Area Damping Control

Observer Design of a Hybrid Model of a Static Var Compensator in a Power System

Full State Feedback H∞ Controller for Improving Small-Signal Stability of Multi-Machine Power Systems

State and Disturbance Observer-Based Controller Design for Fully Actuated Systems

POWER SYSTEMS WIDE-AREA DAMPING CONTROL BASED ON ONLINE SYSTEM IDENTIFICATION

Design of State-Feedback Decentralized Nonlinear H∞ Controllers in Power Systems