Abstract:Achromatic, mean-modulated flicker—wherein luminance increments and decrements of equal magnitude are applied, over time, to a test field—is commonly used in both clinical assessment of vision and experimental studies of visual systems. However, presenting flicker on computer-controlled displays is problematic; displays typically introduce luminance artifacts at high flicker frequency or contrast, potentially interfering with the validity of findings. Here, we present a battery of tests used to weigh the relative merits of two displays for presenting achromatic, mean-modulated flicker. These tests revealed marked differences between a new high-performance liquid-crystal display (LCD; EIZO ColorEdge CG247X) and a new consumer-grade LCD (Dell U2415b), despite displays’ vendor-supplied specifications being almost identical. We measured displayed luminance using a spot meter and a linearized photodiode. We derived several measures, including spatial uniformity, the effect of viewing angle, response times, Fourier amplitude spectra, and cycle-averaged luminance. We presented paired luminance pulses to quantify the displays’ nonlinear dynamics. The CG247X showed relatively good spatial uniformity (e.g., at moderate luminance, standard deviation 2.8% versus U2415b’s 5.3%). Fourier transformation of nominally static test patches revealed spectra free of artifacts, with the exception of a frame response. The CG247X’s rise and fall times depended on both the luminance from which, and to which, it responded, as is to be generally expected from LCDs. Despite this nonlinear behaviour, we were able to define a contrast and frequency range wherein the CG247X appeared largely artifact-free; the relationship between nominal luminance and displayed luminance was accurately modelled using a causal, linear time-invariant system. This range included contrasts up to 80%, and flicker frequencies up to 30 Hz. This battery of tests should prove useful to others conducting clinical assessment of vision and experimental studies of visual systems.

Influence of Color and Details in Image Content on Flicker Visibility in a Scanning-Backlight LCD

Liquid-Crystal Display (LCD) of achromatic, mean-modulated flicker in clinical assessment and experimental studies of visual systems

Analysis of Image Flicker in Polymer‐Sustained‐Alignment Liquid Crystal Display

Color Breakup in Field-sequential Color Display

The Effects of Colour and Temporal Frequency of Flickering Light on Variability of the Accommodation Response in Emmetropes and Myopes.

Study on the Effects of Display Color Mode and Luminance Contrast on Visual Fatigue

Flicker Analysis of Lighting Products and Effect of Functional Lighting

Effect of LED Wavelength Consistency and Temperature Uniformity on Color Difference of LCD Backlight

The Effects of Flicker from Fluorescent Lighting on the Function of Visual Accommodation

Color Filter-Less Technology of LED Back Light for LCD-TV

Subjective assessment of visual fidelity: Comparison of forced‐choice methods

An Evaluation Method for Lighting Flicker Based on Frequency Spectrum Analysis

Video Illumination Compensation Algorithm with Flicker Eliminate

Non-visual Effects of Flat Panel Display with Light Emitting Diode Backlight on Human

Investigation on Improving Color Crosstalk for High-Transmittance TFT-LCDs

Effect of Illuminance and Light Strobe on Attention and Visual Fatigue in Indoor Lighting

Optimized Electrophoretic Display: Dynamic Multiwaveform Invocation With Localized Time-Division for Low-Flicker Video Display

Effect of White LEDs on Gamut of TV with Direct Illumination-type LED Backlight

Impact of Temporal Visual Flicker on Spatial Contrast Sensitivity in Myopia

The Research Of Sub-Space Partition Strategy And Bit Scanning Control Method Based On Human'S Vision Nonlinearity Rule

Flicker adaptation improves acuity for briefly presented stimuli by reducing crowding