Abstract:Despite the broad range of navigation, positioning, and timing services offered by the global navigation satellite system (GNSS), its signals are vulnerable to blockage and interference, leading to a degraded performance or even unavailability. In contrast to GNSS, ground-based navigation systems exhibit better layout flexibility and more efficient terrain adaptability in shaded areas, with their additional advantages of accurate station coordinates and the absence of ionospheric delay effects enabling precise point positioning. However, accurate inter-station time synchronization is thought to be necessary for the ground-based precise point positioning. Locata utilizes a proprietary TimeLoc technology for tight time synchronization, allowing the clock difference in the carrier phase measurement equation to be ignored. However, for other ground-based navigation systems, accurate time synchronization requires accurate calibration of equipment delays and thus significantly increases the difficulty of engineering implementation. Herein, we propose a new precise point positioning method that does not rely on accurate inter-station time synchronization. According to this method, the uncalibrated clock difference and the integer carrier phase ambiguity are combined into a new ambiguity parameter, with the ambiguity and position coordinates subsequently solved in two steps. Further, in order to overcome the limitations of the Locata on-the-fly algorithm and the conventional “known-point initialization” method, a new “dynamic key point initialization” method is proposed. Finally, a simulation test and an indoor field trial are conducted, demonstrating that precise point positioning can be achieved by sharing a single clock source without relying on accurate inter-station time synchronization. An atomic clock is not needed and an inexpensive crystal oscillator is sufficient to act as the shared clock. The results of indoor positioning tests reveal real-time centimeter-level accuracy.

A Flexible Low-Cost Time Synchronizer For Gnss/Ins Integration

IEEE 1588 Based Time Synchronization System for a Seafloor Observatory Network

A High Accuracy Time Keeping Scheme Based on GPS

A Two-Step Method for Synchronization of Low-cost GNSS and Visual-Inertial Sensor Timestamps

A Time Synchronization Algorithm Based on Correlation Analysis in GNSS/INS Integrated Navigation

A Hybrid Time Synchronization Optimization Scheme for Onboard Payloads with Independent Clock

Precise point positioning for ground-based navigation systems without accurate time synchronization

Design and Implementation of High-Precision Timing Module for NR Terminals Based on FPGA

Phase Compensation Sensor for Ranging Consistency in Inter-Satellite Links of Navigation Constellation

A Satellite Navigation Relative Timing Method for GNSS-R Miniaturized Passive Location Systems

Hardware-based Solution of Precise Time Synchronization for Networked Control System

Open-Source LiDAR Time Synchronization System by Mimicking GNSS-clock

A Linear Regression-Based Methodology to Improve the Stability of a Low-Cost GPS Receiver Using the Precision Timing Signals from an Atomic Clock

Foundation and performance evaluation of real-time GNSS high-precision one-way timing system

Effects of substitution at serine 40 of tyrosine hydroxylase on catecholamine binding.

A Fast Positioning Method Based On High-Precision Clock For Gnss Receivers

High Precision Synchronization System Based on FPGA

Joint Timekeeping of Navigation Satellite Constellation with Inter-Satellite Links

Deep Coupled Integration Of Csac And Gnss For Robust Pnt

Precision Analysis and Improvement of GPS High Accurate Short Timing Scale Based on FPGA

A Mixed Approach for Clock Synchronization in Distributed Data Acquisition Systems