Abstract:The rate coefficients for activation (k(a0)(app)) of two alkyl halides, methyl 2-bromopropionate, MBrP, and Br-capped poly(methyl acrylate), by Cu-0 were determined under various conditions. The value of k(a0)(app) was studied in two solvents, dimethyl sulfoxide (DMSO) and acetonitrile (MeCN), and their mixtures with methyl acrylate (MA), using tris[2-(dimethylamino)ethyl]amine (Me6TREN) and tris(2-pyridylmethyl)amine (TPMA) as ligands. The experiments showed that the rate of activation increased with the surface area of Cu-0 but was typically not affected by the ratio of ligand to initiator, if a sufficient amount of ligand was present. The choice of solvent and presence of monomer/polymer had a small influence on k(a0)(app). The activation rate coefficient of MBrP was k(a0)(app). 1.8 X 10(-4) cm s(-1) with Me6TREN as the ligand in DMSO at 25 degrees C while the activation rate coefficient of Br-capped poly(methyl acrylate) by Cu was slightly lower, k(a0)(app) = 1.0 X 10(-4) cm s(-1), as measured in a polymerization of MA in MA/DMSO = 1/1 (v/v) with Me6TREN. On the basis of the measured rate coefficients, the activation rate of MBrP by 1 mM (CuBr)-Br-I/Me6TREN (k(a1)(app) = 3.2 X 10(2) M-1 s(-1)) is similar to the activation rate by 2 km Cu-0 wire with diameter of 025 mm in 7 mL of DMSO. Thus, under typical conditions, conducted in the presence of ca. 1 cm Cu-0 wire, alkyl halides are predominantly activated by Cu-I species. Consequently, Cu-0 acts as a supplemental activator and also as a reducing agent (SARA) because cornproportionation dominates disproportionation, for the polymerization of MA in DMSO. These results support the SARA ATRP mechanism rather than the proposed single electron transfer-living radical polymerization (SET-LRP) process, which requires exclusive activation by Cu-0 and instantaneous disproportionation of Cu-I.

The Application of Copper(Ii) Deactivator on the Single-Electron Transfer Living Radical Polymerization of Tert-Butyl Acrylate

Is it ATRP or SET-LRP? part I: Cu0&CuII/PMDETA – mediated reversible – deactivation radical polymerization

Reversible-Deactivation Radical Polymerization in the Presence of Metallic Copper. Activation of Alkyl Halides by Cu0

Copper-Mediated CRP of Methyl Acrylate in the Presence of Metallic Copper: Effect of Ligand Structure on Reaction Kinetics

Controlled Polymerization of Methyl Methacrylate and Styrene Via Cu(0)-Mediated RDRP by Selecting the Optimal Reaction Conditions

In Situ Atom Transfer Radical Polymerization Of Styrene With A Tetraethylthiuram Disulfide/Copper Bromide/2,2 '-Bipyridine Initiating System

"Living" Radical Polymerization of Methyl Methacrylate Using CuBr as Catalyst in [Hmim][CH_3COO]

Single-Electron Transfer Living Radical Polymerization of Vinyl Acetate

Copper(0)-Mediated Reversible-Deactivation Radical Polymerization: Kinetics Insight and Experimental Study

Transition metal catalyzed atom transfer radical polymerization in the presence of a conventional radical initiator

Controlled Polymerization of Acrylamide via One-Pot and One-Step Aqueous Cu(0)-Mediated Reversible-Deactivation Radical Polymerization

Synthesis of zwitterionic polymer by SET-LRP at room temperature in aqueous

Where is the induction from? Effect of disproportionation and comproportionation in Cu(0)-mediated reversible deactivation radical polymerization

Miniemulsion Single Electron Transfer-Degenerative Chain Transfer Polymerization of Butyl Acrylate

Cu(0)/2,6-Bis(Imino)Pyridines Catalyzed Single-Electron Transfer-Living Radical Polymerization Of Methyl Methacrylate Initiated With Poly(Vinylidene Fluoride-Co-Chlorotrifluoroethylene)

Reverse Atom-Transfer Radical Polymerization at Room Temperature

Soluble and Recoverable Support for Copper Bromide-Mediated Living Radical Polymerization

Atom Transfer Radical Polymerization of N,N‐Dimethylacrylamide

In Situ Cu(0) Catalyzed SET‐LRP: the First Attempt

Highly active copper-based catalyst for atom transfer radical polymerization.

In-depth mechanistic and kinetic investigation of sonochemically mediated atom transfer radical polymerization using modeling approach