Microstructures and Electrochemical Properties of Mg0.9Ti0.1Ni1−xMx (m=co, Mn; X=0, 0.1, 0.2) Hydrogen Storage Alloys

HongXia Huang,KeLong Huang,SuQin Liu,DongYang Chen
DOI: https://doi.org/10.1016/j.powtec.2009.11.003
IF: 5.64
2010-01-01
Powder Technology
Abstract:Mg–Ni–Ti-based hydrogen storage alloys Mg0.9Ti0.1Ni1−xMx (M=Co, Mn; x=0, 0.1, 0.2) were prepared by means of mechanical alloying (MA). The effects of partial substitution of Ni with Co or Mn on the microstructures and electrochemical performance of the alloys were investigated. The result of X-ray diffraction (XRD) shows that the alloys exhibit dominatingly amorphous structures. The electrochemical measurements indicate that the substitution of Ni can dramatically enhance the cycle stability of Mg–Ni–Ti-based alloys. After 50 charge/discharge cycles, the capacity retention rate of the alloy electrodes increases from 30% (Mg0.9Ti0.1Ni) to 59% (Mg0.9Ti0.1Ni0.9Co0.1), 58% (Mg0.9Ti0.1Ni0.9Mn0.1), 46% (Mg0.9Ti0.1Ni0.8Co0.2) and 53% (Mg0.9Ti0.1Ni0.8Mn0.2), respectively. Among these alloys, the Mg0.9Ti0.1Ni0.9Mn0.1 alloy presents better overall electrochemical performance. The cyclic voltammograms (CV) and anti-corruption test reveal that the electrochemical cycle stability of these alloys is improved by substituting Ni with Co or Mn.
What problem does this paper attempt to address?