Batch- and continuous propionic acid production from glycerol using free and immobilized cells of Propionibacterium acidipropionici
Tarek Dishisha,Maria Teresa Alvarez,Rajni Hatti-Kaul
DOI: https://doi.org/10.1016/j.biortech.2012.05.079
IF: 11.4
2012-08-01
Bioresource Technology
Abstract:Propionic acid production from glycerol was studied using Propionibacterium acidipropionici DSM 4900 cells immobilized on polyethylenimine-treated Poraver (PEI-Poraver) and Luffa (PEI-Luffa), respectively. Using PEI-Luffa, the average productivity, yield and concentration of propionic acid from 40 g L(-1) glycerol were 0.29 g L(-1) h(-1), 0.74 mol(PA) mol(Gly)(-1) and 20 g L(-1), respectively, after four consecutive recycle-batches. PEI-Poraver supported attachment of 31 times higher amounts of cells than PEI-Luffa and produced 20, 28 and 35 g L(-1) propionic acid from 40, 65 and 85 g L(-1) glycerol, respectively (0.61 mol(PA) mol(Gly)(-1)). The corresponding production rates were 0.86, 0.43 and 0.35 g L(-1) h(-1), which are the highest reported from glycerol via batch or fed-batch fermentations for equivalent propionic acid concentrations. Using a continuous mode of operation at a dilution rate of 0.1 h(-1), cell washout was observed in the bioreactor with free cells; however, propionic acid productivity, yield and concentration were 1.40 g L(-1) h(-1), 0.86 mol(PA) mol(Gly)(-1), and 15 g L(-1), respectively, using immobilized cells in the PEI-Poraver bioreactor. The choice of the immobilization matrix can thus significantly influence the fermentation efficiency and profile. The bioreactor using cells immobilized on PEI-Poraver allowed the fermentation of higher glycerol concentrations and provided stable and higher fermentation rates than that using free cells or the cells immobilized on PEI-Luffa.
energy & fuels,biotechnology & applied microbiology,agricultural engineering