Abstract:The co-removal of CO2 while removing SO2 and NOx from industrial flue gas has great potential of carbon emission reduction but related research is lacking. In this study, a wet scrubbing process with various urea solutions for desulfurization and denitrification was explored for the possibility of CO2 absorption. The results showed that the urea-additive solutions were efficient for NOx and SO2 abatement, but delivered < 10% CO2 absorption efficiency. The addition of Ca(OH)2 dramatically enhanced the CO2 absorption, remained the desulfurization efficiency, unfortunately restricted the denitrification efficiency. Among various operating parameters, pH of solution played a determining role during the absorption. The contradictory pH demands of CO2 absorption and denitrification were observed and discussed in detail. A higher pH of solution than 10 was favorable for CO2 absorption, while the oxidizing of NO to NO2, NO2- or NO3- by NaClO2 was inhibited in this condition. When 7 < pH < 10, it was favorable for the conversion and absorption of NO and NOx. However, the conversion of HCO3- to CO32- was significantly inhibited, hence preventing the absorption of CO2. Large part of Ca(OH)2 became CaCO3 with a finer particle size, which covered the unreacted Ca(OH)2 surface after the reaction. Kinetic analysis showed that the CO2 absorption in urea-NaClO2-Ca(OH)2 absorbent was controlled by chemical reaction in early stage, then by ash layer diffusion in later stage.

Simultaneous removal of SO2 and NO x by calcium hydroxide at low temperature: Evolution of the absorbent surface structure

Simultaneous removal of SO2 and NOx by calcium hydroxide at low temperature: Effect of SO2 absorption on NO 2 removal

Simultaneous removal of SO2 and NO by using calcium absorbent with KMnO4 as additive

Simultaneous wet desulfurization and denitration by an oxidant absorbent of NaClO2/CaO2

Reaction mechanism of NO and SO2 Co-removal by calcium hydroxide

Simultaneous wet absorption of SO2 and NOX with mixed Na2SO3 and (NH4)2SO3: Effects of mass concentration ratio and pH

Simultaneous Removal of SO2 and NO from Flue Gas with Calcium-Based Sorbent at Low Temperature

SO 3 removal by submicron absorbents synthesized via inhibition method: The product layer grows like parallel peaks

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Simultaneous Removal of SO2 and NOx by Calcium-Based Sorbent with NH3 Injection at Moderate Temperatures

Simultaneous Absorption of SO2 and NO from Flue Gas with CaCO3 and Liquid Phase Oxidation

Performance and mechanism of CO2 absorption during the simultaneous removal of SO2 and NO by wet scrubbing process

Chain Reaction Mechanism by NO<i><sub>x</sub></i>in SO<sub>2</sub>Removal Process

Simultaneous Absorption of SO2 and NO from Flue Gas with KMnO4/CaCO3 Slurry

Simultaneous Removal of SO2 and NO by FeII(EDTA) Solution: Promotion of Mn Powder and Mechanism of Reduction

Simultaneous Removal of SO2 and Trace SeO2 from Flue Gas: Effect of Product Layer on Mass Transfer.

Simultaneous removal of SO2 and NO using a spray dryer absorption (SDA) method combined with O3 oxidation for sintering/pelleting flue gas

Investigation on removal of noX and SO2 from flue gas by combined ozone with absorption and by-product treatment

Experiment on Simultaneous Absorption of NO and SO2 from Sintering Flue Gas by Oxidizing Agents of KMnO4/NaClO

Simultaneous Removal of SO<sub>2</sub>and Trace SeO<sub>2</sub>from Flue Gas: Effect of Product Layer on Mass Transfer

Study on Competitive Absorption of SO3 and SO2 by Calcium Hydroxide