Control effect of fracture system on fluid migration, chemical reaction, and carbon dioxide storage
Leilei Yang,Guo Wei,Weiquan Zhao,Jing Hu,Guangyou Zhu,Qi Liu
DOI: https://doi.org/10.1088/1755-1315/861/7/072023
2021-10-01
IOP Conference Series: Earth and Environmental Science
Abstract:Carbon dioxide (CO2) injection alters a reservoir’s original equilibrium, leading to gas–liquid–solid reactions within the reservoir, resulting in mineral dissolution and precipitation affecting the reservoir’s physical properties. Because of their good permeability, faults are critical in fluid dredging and dominant channel formation. The characteristics of faults, including their width and strata length, directly affect the path, distance, and range of fluid migration and exert further control on the trend of water–rock–gas geochemical reactions. This study focused on the control effect of the fracture system on the migration, reaction, and storage of supercritical CO2. The faulted Cretaceous reservoir in the Kela-2 gas field of the Tarim Basin was selected as the study formation, and 10 heterogeneous profile models were established using multiphase-flow, solute-transport numerical simulation. The differences in fluid migration and reaction ranges under different fracture lengths, fracture widths, fracture physical properties, and CO2 injection rate conditions were examined. The real-time changes in profile porosity were quantitatively determined, and the control effect of the fracture system on reservoir development was analyzed. The results showed that CO2 fluid entering the formation migrates primarily along the fault. Under the condition of a wider fracture, the fracture’s fluid accumulation and reaction range increase, the degree of acidification is weak, and the ultimate porosity increase is small. When the fracture extends into the reservoir over a greater distance, fluid migrates over a greater distance, and the effect on both sides of the fracture is weak because of less fluid accumulation. Similarly, a higher injection rate causes a longer migration, producing a thin and long injection region similar to that of a long fracture. Better fracture properties result in a more obvious dredging effect. When the fracture’s permeability is insufficient, the injected fluid accumulates at the bottom of the fault, and eventually, only the porosity at the base of the fault changes significantly. In conclusion, the fracture system plays a very important role in controlling fluid migration, reaction, and reservoir development through induced reactions, and different fracture conditions lead to different reservoir development conditions.