Air source heat pump with water heater based on a bypass-cycle defrosting system using compressor casing thermal storage
Zhongbao Liu,Pengyan Fan,Qinghua Wang,Ying Chi,Zhongqian Zhao,Yuanying Chi
DOI: https://doi.org/10.1016/j.applthermaleng.2017.09.131
IF: 6.4
2018-01-01
Applied Thermal Engineering
Abstract:In this study, the defrosting system of an air source heat pump utilizing compressor casing heat storage combined with a hot gas bypass cycle (ASHP-CCHS-HGBC) was designed. The phase change material for defrosting was selected, the phase change heat storage exchanger was devised, and the ASHP-CCHS-HGBC test system was established. The power consumption, defrosting time, and the influence of the indoor exchanger outlet on the air temperature in the ASHP-CCHS-HGBC method were then compared with those of the reverse-cycle defrosting (RCD) and electric heating defrosting (EHD) methods. Experimental results reveal that the total defrosting time and consumption of the ASHP-CCHS-HGBC method was 100s and 43.6kJ, respectively. These values were lower by 10s (9%) and 12.1kJ (21.7%) relative to those of RCD. Moreover, the compressor suction temperature was increased by 10.1°C during defrosting by ASHP-CCHS-HGBC. Under the normal heating operation for 2.5h, 10L hot water with a temperature of 30°C was obtained, the compressor casing temperature was reduced by 4.6°C. While defrosting, the air temperature of the indoor heat exchanger outlet declined to only 3.3°C and exerted the least influence on the indoor temperature among those of the three defrosting methods.
energy & fuels,engineering, mechanical,thermodynamics,mechanics