Cyclohexane Oxidation over Nano Gold Catalysts Supported on Zirconia-Modified Alumina

许立信,何潮洪,朱明乔,吴可君,徐亚兰,赵静

DOI: https://doi.org/10.3321/j.issn:1003-9015.2009.02.023

2009-01-01

Abstract:Nano gold catalysts supported on zirconia-modified alumina were prepared via the modified direct anionic exchange method(DAE),and the zirconia-modified alumina supports were prepared by wet impregnation method.The catalytic performances of the prepared catalysts for the catalytic oxidation of cyclohexane into cyclohexanone and cyclohexanol were investigated by using the oxygen as the oxidant.The results show that,increasing the zirconia content in the catalyst,its catalytic activity is well retained,and the selectivity of cyclohexanone and cyclohexanol,especially that of the cyclohexanone,can be remarkably enhanced.It was also found that,in the catalyst prepared,the lower the gold content,the smaller the size of the nano gold particles and the higher the catalytic activity the catalyst has.The prepared catalysts with nano gold particle sizes smaller than 6 nm exhibit relatively very high catalytic activity.Under the reaction conditions of 423 K,1.5 MPa and 3 h,using the gold catalyst supported on zirconia-modified alumina with 0.6%(wt) gold and 17%(wt) zirconia,the cyclohexane conversion ratio can reach 9.5% and the selectivity of cyclohexanone and cyclohexanol are 38.8% and 51.5%,respectively.