Abstract:Two kinds of oxygen/fluorine/nitrogen mixtures with large concentration of oxygen have been used to oxyfluorinate low density polyethylene (LDPE). The O 2 /F 2 /N 2 volume fraction in the mixtures was 1/1/4 and 2/1/4, respectively. Both the original LDPE and oxyfluorinated samples are plate of 0.25~0.30 mm in thickness. The space charge characteristics of the original LDPE and the oxyfluorinated samples were tested by using the pulsed electro acoustic (PEA) method. Scanning electron microscope (SEM) and attenuated total reflection infrared (ATR-IR) as well as X-ray photoelectron spectroscopy (XPS) were employed to characterize the morphology and the chemical composition of the oxyfluorinated layer, respectively. It was discussed that the effects of the high concentration of oxygen on the space charge characteristics of the LDPE. The relationship between it and the chemical composition evolution of the oxyfluorinated layer was studied, too. The results show that space charge distribution at the surface layer of the LDPE plate changes largely after the oxyfluorination. Positive heterocharge appears near the cathode in the oxyfluorinated samples, which was different from the situation in the original LDPE with only homocharge. The space charge amount increases with the enhancement of the oxyfluorination condition. The reason is considered that oxyfluorination alters the chemical components and microstructure of the oxyfluorinated surface layer, which lowers the trap level of hole and deepens that of electron. Therefore, hole injection from the anode increases and electron injection from the cathode decreases. It results in the accumulation of positive heterocharge near the cathode. Besides, large concentration of oxygen leads to obvious introduction of O atom at the initial oxyfluoriantion stage. However, the formation rate of C=O groups is obviously restrained by the enhancement of oxyfluorination degree. The results obtained are helpful for deepen understanding about the effect of oxyfluoriantion on dielectric properties of LDPE and the mechanism.

Charge Injection Behaviors of Surface Oxyfluorinated Linear Low Density Polyethylene

Space Charge Accumulation in Linear Low-Density Polyethylene with Surface Fluorination of the Semiconductive Electrode

Space Charge Characteristics of Low Density Polyethylene Oxyfluorinated with High Concentrations of Oxygen

Surface Potential Decay on LDPE and Its Nanocomposites

Space Charge Characteristics of Fluorinated Polyethylene: Different Effects of Fluorine and Oxygen

Electrostatic Potentials in Gas–solid Fluidized Beds Influenced by the Injection of Charge Inducing Agents

Space Charge Injection in LDPE by Semi-conductive Electrode with Different Carbon Black Filling Rates

Influence of oxidation on space charge dynamics in DC aged low-density polyethylene

Surface Modification-Dominated Space-Charge Behaviors of LDPE Films: A Role of Charge Injection Barriers

Effect of Surface Fluorination on Space Charge Behavior at LDPE/EPDM Interface

Surface Layer Fluorination-Modulated Space Charge Behaviors in HVDC Cable Accessory

Charge carrier transportation in the composite of Nano-MgO and cross-linking polyethylene

Space Charge Dynamics of CF4 Fluorinated LDPE Samples from Different Fluorination Conditions and Their DC Conductivities

Investigation on Heterocharge Accumulation in Crosslinked Polyethylene: Experiment and Simulation

Influence Of Applied Voltage On Space Charge Formation And Accumulation Characteristics Of Low Density Polyethylene

Mobility‐limited charge injection in cross‐linked polyethylene under extra high electric field

Investigation of Effects of Charge Injection and Intrinsic Ionic Carriers in Low-Density Polyethylene and Cross-Linked Polyethylene

The Voltage Endurance of Low Density Polyethylene with Surface Treated Inorganic Filler

Trap-Controlled Charge Decay and Quantum Chemical Analysis of Charge Transfer and Trapping in Xlpe

Estimation of charge injection at Al/LDPE interface based on space charge and external current measurement

Space Charge Distribution and Crystalline Structure in Polyethylene Blended with EVOH