Abstract:The stereo-vision methods have been developed and used for measuring the wing deformation while the aircraft is in flight. However, it is difficult to achieve accurate measurement in flight test since inevitable camera movements often occur due to elasticity in the camera support and the surrounding structure, especially during heavy turbulence and large maneuver flight. Any slight camera movements within a stereo-vision system can directly influence the calibrated extrinsic parameters, then decrease 3D reconstruction accuracy, and even cause the measurement to fail. This study proposes a method to correct the effect of the camera movements to enable accurate wing deformation measurement using a stereo-vision system. A reference coordinate system is established based on the control points to unify the changing camera coordinate system. A dynamic extrinsic parameters calibration algorithm is developed to estimate the instantaneous position and orientation of the stereo cameras. To verify the presented method, an experiment in which the stereo cameras occurring relative movement was performed. The results show that the proposed method has effectively corrected the effects of camera movements. Furthermore, the proposed method was applied to the practical wing deformation measurement of a UAV in fieldwork. The maximum error of length and displacement is less than 0.8 mm when the stereo cameras remained unchanged. The actual accuracy of the overall measurement system is about 0.01% of the observed area (e.g. 0.8 mm in 6 m scale) under the conditions of flat viewing angle and outdoor scenes. While camera movements occur during the test, the corrected RMS error of displacement is reduced to about 1.5 mm and has decreased by 50% compared with that before correction. The enhanced precision and robustness of wing deformation measurement are well realized by the proposed method of correcting camera movements.

Study on Deformation Measurement of Position and Attitude Based on Monocular Vision

Realization of odometry system using monocular vision

Unconstrained Self-Calibration of Stereo Camera on Visually Impaired Assistance Devices.

Development of a Monocular Vision System for Robotic Drilling.

High-speed 360 3D shape measurement based on visual stereo phase unwrapping method

Planar Visual Metrology Using Partition-Based Camera Calibration

A New Method for Increasing Accuracy of Distance Measurement Based on Single Visual Camera

Accuracy Analysis and Verification Method on Vision Position-pose Measurement System

Position and pose measurement technology of space combination ground experiment based on machine vision

A Position and Attitude Measurement Method Based on Laser Displacement Sensor and Infrared Vision Camera

A Review of Computer Vision-Based Structural Deformation Monitoring in Field Environments

Monocular vision based 3D vibration displacement measurement for civil engineering structures

A Stable, Efficient, and High-Precision Non-Coplanar Calibration Method: Applied for Multi-Camera-Based Stereo Vision Measurements

Wireless Binocular Stereovision Measurement System Based on Improved Coarse-to-Fine Matching Algorithm

Vanishing feature constraints calibration method for binocular vision sensor.

A Monocular Visual Positioning Method with Scale Information Using a Single Image Sensor

Accuracy Improvement of Binocular Vision Measurement System for Slope Deformation Monitoring

Wing Deformation-Aware Vision-Based Airplane Attitude Measurement

Wing deformation measurement using the stereo-vision methods in the presence of camera movements

Three-dimensional Structural Displacement Measurement Using Monocular Vision and Deep Learning Based Pose Estimation

Self-calibrating technique for 3D displacement measurement using monocular vision and planar marker