Abstract:A laminar coflow CH4/air diffusion flame was experimentally and numerically studied to elucidate the mechanism of flame attachment and the importance of preheating, thermal boundary condition at the fuel tube, and burner geometry to the flame attachment location. OH*-P-chemiluminescence images were captured using an intensified CCD camera. The temperature of the outer surface of fuel tube at 2 mm below the burner exit was measured using a K-type thermocouple. Detailed simulations based on five different burner wall models were conducted to investigate the influence of preheating effect and burner geometry on flame attachment. The conjugate heat transfer between the heat-conducting burner wall and the surrounding gas flows was considered in the overall flame model to account for the preheating effect without or with less ad hoc assumptions for the burner inlet conditions. The effect of different thermal boundary conditions imposed at the fuel tube on the predicted flame attachment location was investigated. Results show that it is paramount to specify the inlet location at a certain distance upstream the burner exit to model the flame attachment phenomenon. This finding can be explained in terms of the direct heating of the fuel and air streams by the flame base or the mixing process between the fuel and air streams associated with the hydrodynamics and diffusion in the vicinity of the burner rim. The thermal boundary condition at the fuel tube only slightly affects the predicted flame attachment location. The fuel decomposition occurs inside the fuel tube mainly due to preheating by the fuel tube wall and the key chemical pyrolysis process was revealed through a detailed kinetics analysis. The efflux of CH4 to the air side over the burner rim was found responsible for the flame attachment under current conditions. The flame base kernel is established around the stoichiometric mixture and its location is controlled by the thermal condition and geometry of the burner wall. The burner geometry influences the position of flame attachment on the outer surface of the fuel tube through the fuel tube heat capacity and the shape. (C) 2018 Published by Elsevier Inc. on behalf of The Combustion Institute.

Evaporating Interface In A Capillary Tube With High Heat Flux Induced By Micro Diffusion Flame

Spray flames in an air-heptane swirling combustor

Measurement of Interacting Ethanol Droplets Evaporation at Moderately Elevated Temperature and Pressure Using Phase Rainbow Refractometry

Interface-resolved simulation of the evaporation and combustion of a fuel droplet suspended in normal gravity

Influence of Preheating and Burner Geometry on Modeling the Attachment of Laminar Coflow CH4/air Diffusion Flames

Characteristic Visualization of the Micro/mesoscale Liquid Ethanol Diffusion Flame by Using Deflection Tomography

A study on liquid film and evaporation characteristics of fuel jet impingement on the scorching wall of evaporation tube for gas turbine

Instability of Flame in Micro-Combustor under Different External Thermal Environment

Interfacial Wave Behavior and Its Effect on the Flow and Condensation Heat Transfer in a Microtube

Evaporation and Combustion Characteristics of Hydrocarbon Fuel Droplet in Sub- and Super-Critical Environments

Effects of evaporation on chemical reactions in counterflow spray flames

An Experimental Study on the Phenomena Inside the Burning Aviation Kerosene Droplet

On the evolution of fuel droplet evaporation zone and its interaction with the flame front in ignition of spray flames

Evaporation Characterization Of Fuel Spray Impinging On A Flat Wall By Laser-Based Measurement

Puffing/micro-explosion of two-liquid droplets: Effect of fuel shell composition

A molecular dynamics study of evaporation of multicomponent stationary and moving fuel droplets in multicomponent ambient gases under supercritical conditions

Evolution of Flame Kernel in One Eddy Turnover of High-Speed Droplet Laden Shear Layers

Experimental investigation on flame spread over jet fuel with influence of external heat radiation

A Priori and a Posteriori Studies of a Novel Spray Flamelet Tabulation Methodology Considering Evaporation Effects

Effect of micro-explosion of biodiesel and ethanol droplets on evaporation: A three-stage mixed fuel droplet evaporation model

Boiling Evaporation Of Typical Fuel Leaked On Heated Surface