Abstract:This paper proposes a systematic approach to the modeling of the small-signal characteristics of three-phase bridge boost rectifiers under non-sinusoidal conditions. The main obstacle to the conventional synchronous d-q frame modeling approach is that it is unable to identify a steady-state under non-sinusoidal conditions. However, for most applications under non-sinusoidal conditions, the current loops of boost rectifiers are designed to have a bandwidth that is much higher than typical harmonics frequencies in order to achieve good current control for these harmonic components. Therefore a quasi-static method is applied to the proposed modeling approach. The converter small-signal characteristics developed from conventional synchronous frame modeling under different operating points are investigated and a worst case point is then located for the current loop design. Both qualitative and quantitative analyses are presented. It is observed that operating points influence the converter low frequency characteristics but hardly affect the dominant poles. The relationship between power stage parameters, system poles and zeroes is also presented which offers good support for the system design. Both the simulation and experimental results verified the analysis and proposed modeling approach. Finally, the practical case of a parallel active power filter is studied to present the modeling approach and the resultant regulator design procedure. The system performance further verifies the whole analysis.

Small Signal Model for Boost Phase-shifted Full Bridge Converter in High Voltage Application

Research on the Current-fed Phase Shift Full Bridge DC/DC Converter

Common-Mode Filter Design for a Transformerless ZVS Full-Bridge Inverter

Transformer Secondary Leakage Inductance Based ZVS Dual Bridge DC/DC Converter

Analysis and Design for Single-Phase Three-Level Boost PFC Converter with Quasi-Static Model

Leakage Current Suppression for Transformerless Zvs Full-Bridge Inverter

Small Signal Modeling And Analysis Of Interleaved Active-Clamp Forward Converter With Parallel Input And Series-Parallel Output

Modeling, Analysis and Design of 15kw Zero-Voltage Zero-Current Switched Full Bridge PWM Converter

Small-Signal Modeling And Control Of Three-Phase Bridge Boost Rectifiers Under Non-Sinusoidal Conditions

A Hybrid ZVS Full-Bridge Converter with Transformer Winding Series-Parallel Auto Regulated Current Doubler Rectifier

A hybrid ZVZCS phase-shift full-bridge converter with series/parallel auto-regulated transformer windings

Model and Simulation of ZVZCS Full-Bridge Converter Based on Effective Duty Cycle

Modeling of Phase‐shifted Full‐bridge ZVS Converter Based on a New Expression of Effective Duty Ratio

Small-Signal Modeling for Phase-Shift Controlled Resonant Converters

Improved small signal model for voltage-boosting converter with hybrid energy pumping

Improved Small Signal Modeling and Dynamic Analysis of High Step-Up Converter with Charged Pump and Boost Converter

An Improved Phase-Shifted Full-Bridge Converter With Wide-Range ZVS and Reduced Filter Requirement.

Integrated Magnetics ZVS Full-Bridge Converter with Phase-Shift control

Esp-Based Nonlinear Description And Solution Of Boost Converter Considering Devices Mechanism Model

Modulated-Coupled-Inductor-Based ISOP Phase-Shifted Full-Bridge Converter with Wide ZVS Range and Reduced Duty Cycle Loss

Hybrid Mode Control for Wide Range Soft-Switched Full-Bridge Converter with Auxiliary Parallel Inductor Networks