Abstract:The static synchronous compensator (STATCOM) is well known as a reactive power compensator with the best performance in the power system recently, which is used in power systems to regulate the line voltage, enhance the power transmission capacity and extend the transient stability margin. STATCOM is conventionally realized by a voltage-source converter; however, being a current injection device, its performance can be improved when realized by a current-source converter (CSC) that can generate a controllable current directly at its output terminals. A STATCOM based on the current-source converter topology is proposed. The nonlinear model of the current-source converter, which is the source of the difficulties in the controller design, has been modified to a linear model through a novel modeling technique. The proposed modeling technique is not based on the linearization of a set of nonlinear equations around an operating point. Instead, the power balance equation and a nonlinear input transformation are used to derive a linear model independent of the operating point. This model acts as the basis for the design of a decoupled state-feedback controller. The proposed STATCOM has been simulated using the PSCAD/EMTDC package. The simulation results show that a CSC-based STATCOM can result in excellent current and voltage waveforms as well as very short response time while operating at a low switching frequency. This makes the proposed scheme suitable for high power applications. Ill. 6, bibl. 11 (in English; summaries in English, Russian and Lithuanian).

An Analysis on the Influence of Interface Inductor to STATCOM System with Phase-Shift Control and Corresponding Design Considerations

Analysis and Design of the Interface Inductor and the DC Side Capacitor in a STATCOM with Phase and Amplitude Control Considering the Stability of the System

Impedance Network Impact on the Controller Design of the QZSI for PV Applications

Design of Input Filters Considering the Stability of STATCOM Systems

Control and modulation for APF-STATCOM based on cascaded H-bridge converter

Design of parameters in static synchronous compensator with indirect current control based on the system stability

Control Scheme of Three-phase H-bridge Cascaded STATCOM

A DC capacitor voltages balancing control strategy for cascade D-STATCOM

Intelligent Parameter Design-Based Impedance Optimization of STATCOM to Mitigate Resonance in Wind Farms

High Performance Control Strategy Based on Three-Phase Four-Wire Cascaded DSTATCOM

The Nonlinear Internal Control of STATCOM: Theory and Application

Interaction Analysis of SVC and STATCOM Controllers Based on RGA Principle

Study on Direct Power Control of Static Synchronous Compensator Based on Virtual Flux Linkage

Impedance Characteristic Analysis and Phase-locked Angle Feedforward-based Stability Improvement for LCC-HVDC in Sending AC Grid

Study of STATCOM control for power swings damping improvement

Control and Simulation of STATCOM Integrated Energy Storage System

Nonlinear Control of STATCOM under Unbalanced Condition

State-feedback Control of a Current Source Inverter-based STATCOM

Analysis on Mechanism of Power Oscillation Mitigation by STATCOM

Influence of Design Parameters Upon STATCOM Performance for Asymmetric Power Systems

A Novel Controller Design For Statcom Based On The Concept Of Area Center Of Inertia