Abstract:ObjectivesThis paper aims to study the influencing factors and mechanisms of ship model resistance prediction uncertainty, as well as proposing corresponding suppression methods. MethodsResistance tests and local flow measurements on the flow around KCS models of 1.725 m and 3.450 m are carried out in a circulating water channel. The effects of the model scale on the resistance predictions are obtained by comparing the results of the two tests. Numerical simulations of the flow around the 3.450 m model in an unbounded water area and circulating water channel are achieved. The results under the two conditions are compared to analyze the blockage effect and validate the simplified Tamura correction formula. Numerical simulations of the flow around the 3.450 m model under different turbulence intensities in a circulating water channel are then carried out to analyze the effects of turbulence intensities on resistance predictions. ResultsThe results show that the resistance prediction uncertainty of small ship models due to statistics collections and inflow uniformity can be amplified if the inflow velocity is too low. This demonstrates that the blockage effect of the large model could increase hull sinkage, pressure gradients on the hull and wave amplitudes, leading to an increase in ship resistance. The average difference between the resistances predicted in the unbounded water area and circulating water channel is 4.56% without correcting for the blockage effect. The difference is reduced to 2.25% with the correction of the simplified Tamura formula. The total resistance increases by an average of 3.75% as the turbulence intensity increases from 1% to 2%. It is observed that the decay of turbulence intensity along the flow direction is linear from the entrance to the bow. ConclusionsThis study shows that reasonably large models should be used wherever possible and the turbulence intensity should be strictly controlled to reduce the uncertainty of ship resistance tests in circulating water channels. In addition, the simplified Tamura formula should be used to correct the blockage effect, and the appropriate inflow turbulence intensity should be used in numerical prediction according to the dissipation of the turbulence intensity.

Numerical studies on resistance prediction methods for submerged bodies

Numerical Prediction of Submarine Hydrodynamic Coefficients Using CFD Simulation

A Numerical Study on the Resistance Prediction of a Medium Speed Craft

Numerical Simulation of Resistance and Flow Field for Submarines near Ice Surface

Scale effects on the hydrodynamic performance of a submerged body

Uncertainty suppression methods for CFD/EFD resistance prediction of ship model

Full-scale CFD simulations for the determination of ship resistance as a rational, alternative method to towing tank experiments

The Effects of Reynolds Number on Resistance and Wake of Ship

The Numerical Simulation of a Towing Cylinder Based on Immersed Body Boundary Method

A numerical study of resistance and viscous flow around typical benchmark surface ship hull

Hydrodynamic Forces on a Partially Submerged Cylinder at High Reynolds Number in a Steady Flow

Rans-Based CFD Prediction of the Hydrodynamic Coefficients of Darpa Suboff Geometry in Straight-Line and Rotating Arm Manoeuvres

Resistance and flow field of a submarine in a density stratified fluid

Research on Mesh Generation Effecting Resistance Calculation

A Numerical Prediction of the Resistance of Bulk Carriers in Brash Ice Channels

Numerical Simulations of Flows Around Subsea Cover

Numerical Simulation of Rotating Arm Test for Prediction of Submarine Rotary Derivatives

Numerical Study on Added Resistance Computations in Short Waves

Study of Hydrofoil Boundary Layer Prediction with Two Correlation-Based Transition Models

Resistance Calculation and Motion Simulation for Deep Sea Open-Framed Remotely Operated Vehicle Based on Hydrodynamics Test

A Numerical Calculation of Resistance of an Inland Large Self-propulsion Cutter Suction Dredger in Shallow Water