Abstract:Thermal control device based on thermochromis plays an important role in spacecrafts thermal management by automatically adjusting its radiative properities in response to large temperature gradients. The thermal management ability was determined by the device surface radiation performance. During the sun shadow, it is required to dissipate heat as little as possible from spacecraft, which is a low emittance device. While, it desired the device emittance is large enough to meet the heat dissipation requirement facing with the direct sunlight. As a type thermochromic material, La1 - x Sr x MnO3 (LSMO) has obtained broad attention because it showed a considerable superiority in saving energy consumption in space thermal management. It can hold the heat at low temperature due to its low emittance behavior, whereas dissipate the excess heat at high temperature for its high emittance properties. In this work, we prepared the La1 - x Sr x MnO3 ( x= 0125, 0.175, and 0.2) nanoparticles by sol-gel method from the precursors such as lanthanum nitrate hexahydrate, strontium nitrate and manganese nitrate solution (50%). LSMO nanoparticles were dispersed homogeneously in a solution of resins. The mixture then was spin-coated on the clean Al substrates. After standing for 10 h, the coating was cured at 120°C. The structure, morphology, and composition analysis of LSMO nanoparticles or coatings were investigated by X-ray diffraction technique, scanning electron microscopy, and the energy dispersive X-ray spectroscopy, respectively. The total hemispherical emittance of coating was measured by calortmetric method, which test sample was suspended in the center of a liquid nitrogen thermostat. According to the input power, sample temperature, and thermostat temperature, the emittance can be indirectly obtained. Two resins, which is the acrylic resin and the solution of terpineol and ethyl cellulose respectively, was considered to investigated the effect of reslin type on the emittance of coatings. The result of X-ray diffraction shows a single perovskite structure for LSMO nanoparticles at different Sr doped level. A fined LSMO nanoparticle with 50–300 nm, which is detected using scanning electron microscopy, can be obtained by control sol-gel process. The composition analysis results show a comparable stoichiometric ratio. The two resins coating show a different surface morphology, which is more compact in acrylic resin than in the terpineol. Experimental results show that the variation amplitude of coating emittance is 0.45 within the temperature range of 173–370 K. For the acrylic resin coating, the emittance changes from 0.42 at 173 K to 0.85 at 370 K, and it rises from 0.39 at 173 K to 0.83 at 370 K in terpineol resin coating.

INVESTIGATION ON ABSORPTIVITY CONTROL OF THERMOCHROMATIC MATERIALS

Investigation on Radiative and Optical Properties of Thermochromatic Materials

Tailoring the Solar Absorptivity of Thermochromic Material La0.7ca0.2sr0.1mno3

A study of Electrochromic thin films and Devices by Photothermal Deflection Technique

Investigation on the Coupling Effect of Thermochromism and Microstructure on Spectral Properties of Structured Surfaces

Radiative Properties of Thermochromic Material with Solar Reflection Films

Investigation on emissive properties of peroskite-type oxide LSMO with grating surface

Investigation of thermal control in phase-changing ABO3 perovskites via first-principles predictions: general mechanism of solar absorptivity

Investigation of thermal control in phase-changing ABO 3 perovskites via first-principles predictions: general mechanism of solar absorptivity.

Investigation of thermal control in phase-changing ABO<sub>3</sub> perovskites <i>via</i> first-principles predictions: general mechanism of solar absorptivity

Perovskite-type oxide films combined with gratings for reduction of material consumption and improvement of thermochromism property

Spatially Resolved Dynamically Reconfigurable Multilevel Control of Thermal Emission

Temperature-dependent Infrared Properties of Ca Doped (la,sr)mno3 Compositions with Potential Thermal Control Application

Temperature-dependent Emissivity Property in La0.7Sr0.3MnO3 Films

Bioinspired Microstructured Materials for Optical and Thermal Regulation

Polycrystalline La0.845Sr0.155MnO3:Ag ceramics (0 ≤ x ≤ 0.5) with room-temperature TCR and MR for improved uncooling photoelectric and magnetic devices

Emissivity and Optical Properties of Thermochromic Material La 0.7 Ca 0.3− X Sr X MnO 3 (0 ≤ X ≤ 0.3)

Smart Materials for Dynamic Thermal Radiation Regulation

Spectral and Directional Control of Thermal Radiation with Periodic Structured Materials

Highly sensitive optical thermometer of Sm 3+ , Mn 4+ activated LaGaO 3 phosphor for the regulated thermal behavior

Total Hemispherical Emittance of Low Temperature Curing Thermochromic Coatings