Abstract:This article deals with Ihe technology of burning natural gas with high-temperature air and large quantities of flue gas. The objective of this work is to assess the potential of several combustion models for their abilities to predict characteristics of the new combustion technology. Three numerical models have been used: (a) an Eddy-Break-Up model with a two-step reaction scheme, (b) an Eddy-Dissipation Concept model with chemical equilibrium and (c) pdf/mixture fraction model with equilibrium, non-adiabatic look up tables for chemistry. The nitric oxide post processors have incorporated thermal and prompt mechanisms as well as the NOx reburning mechanism. The computational results have been compared with both in-furnace measurements (temperature, O2, CO2, CO, CH4, NO, velocities, radiative heat flux) and with the measured furnace exit parameters. All three models have correctly reproduced the characteristics of the high temperature air combustion, namely the uniformity of the temperature field, high radiative fluxes and low NOx and CO emission. With the exception of a small region located within the natural gas jets, the chemical equilibrium assumption with respect to both natural gas combustion and equilibrium O, OH and N radicals have resulted in predictions of very good quality. The Eddy Dissipation Concept model and the pdf/mixture fraction model have provided almost identical results. The tested combustion models cannot describe the chemistry and temperature field in the fuel jet region. This is partially caused by imperfections in predicting the entrainment of the weak methane jet interacting with the strong combustion air stream. A more comprehensive understanding of the chemistry of natural gas combustion under fuel-rich conditions with comburent containing 3-4% oxygen is required to develop appropriate non-equilibrium sub-models for this fuel jet region.

Numerical Study on High Temperature Air Combustion Characteristics of Natural Gas

Numerical Study on High Temperature Air Combustion in U-Type Tube

NUMERICAL SIMULATION OF COMBUSTION OF NATURAL GAS WITH HIGH-TEMPERATURE AIR

Numerical simulation of NOx emission during high temperature air combustion for burning low heat value gas

NUMERICAL ANALYSIS OF HIGH TEMPERATURE COMBUSTION OF METHANE

Numerical Study of Flame Properties and Nitrogen Oxide Formation in High Temperature Air Combustion

EXPERIMENTAL STUDY ON THE NOx EMISSION OF HIGH TEMPERATURE AIR COMBUSTION

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas

Investigation on Combustion Characteristics and NO Formation of Methane with Swirling and Non-Swirling High Temperature Air

Numerical Studies of a Water-cooled Premixed Burner for Low NOx Combustion of Natural Gas

Numerical Simulation of High Temperature Combustion for Low Heat Value Gas

Quantitative Analyses of No Formations from Different Reaction Pathways in Methane-Air Combustion at Various Pressures and Temperatures

Numerical Simulation on Combustion Characteristics of Biofuels with Different Calorific Values

Study on combustion and emission characteristics of a heavy-duty gas turbine combustor fueled with natural gas

Numerical Investigation of a Symmetrical Combustion Burner and External Convection Heat Transfer Characteristics

Influence of Preheated Air Temperature on High Temperature Air Combustion in Furnace with Swirling Burner: a Modeling Study

Numerical Analysis of Flow, Mixture Formation and Combustion in a Direct Injection Natural Gas Engine

Numerical Study of the Influence of Combustion Characteristics with Different Ways of Adding Oxygen

NO formation analysis of turbulent non-premixed coaxial methane/air diffusion flame

Numerical Simulation of Influence of High Temperature Air on Flow in Combustion Backfolw Section

Combustion Performance and NO Emission in Industrial Furnace under Preheated Air Condition with Different Excess Air Ratio